Related papers: Temperature dependent multi-pulse threshold due to…
This paper examines the effect of temperature on the structural stability and mechanical properties of 20 layered (10,10) single walled carbon nanotubes (SWCNTs) under tensile loading using an O(N) tight binding molecular dynamics (TBMD)…
The temperature dependence of the hydrodynamic boundary condition between a PDMS melt and two different non-attractive surfaces made of either an OTS (octadecyltrichlorosilane) self-assembled monolayer (SAM) or a grafted layer of short PDMS…
The influence of low temperatures on the performance of a high-power single-frequency fiber laser amplifier is evaluated with a numerical simulation. Cooling the fiber can allow to take advantage of both higher damping of the acoustic waves…
Carrier Selective (CS) Silicon solar cells are increasingly explored as a low cost alternative to PN junction Silicon solar cells. While the recent trends on power conversion efficiency are encouraging, the temperature coefficient and hence…
The electrical and thermal behavior of nanoscale devices based on two-dimensional (2D) materials is often limited by their contacts and interfaces. Here we report the temperature-dependent thermal boundary conductance (TBC) of monolayer…
We report on the development of some process capabilities for a polymer-based, multi-layer microelectrofluidic platform, namely: the hot embossing process, metallization on polymer and polymer bonding. Hot embossing experiments were…
A complete experimental study of temperature dependence of the total spectral emissivity has been performed, for the first time, for absorber reflector selective coatings used in concentrated solar power (CSP) systems for energy harvesting.…
The effect of the electron temperature on both the light absorption and the scattering by metal nanoparticles (MNs) with excitation of the surface plasmon electron vibrations is studied in the framework of the kinetic theory. The formulae…
A comprehensive numerical modelling of microcavity parameters for micropillar lasers with optical pumping was presented. The structure with a hybrid dielectric-semiconductor top mirror has a significantly higher calculated quality-factor…
We report on reaching sub-Doppler temperatures of $^{40}$K in a single-chamber setup using a dispenser-based potassium source with natural (0.012$\%$ of $^{40}$K) isotopic composition. With gray molasses cooling on the $D_1$-line following…
We report the laser cooling and trapping of neutral potassium on an open transition. Fermionic 40K is captured using a magneto-optical trap (MOT) on the closed 4S-4P transition at 767 nm and then transferred, with unit efficiency, to a MOT…
The temperature of a nonneutral plasma confined in a Penning-Malmberg trap can be determined by slowly lowering one side of the trap's electrostatic axial confinement barrier; the temperature is inferred from the rate at which particles…
The temperature distribution inside a double-cladding optical fiber laser or amplifier is examined in detail. Traditionally, the quantum defect in the core is taken to be the main source of heating in an active optical fiber. However,…
Two-pulse correlation experiments performed using pulses of different intensities on Pd(111) with different CO coverages showed that the CO photodesorption probability depends on whether the strong or the weak pulse arrives first to the…
The Plastic Scintillator Detector (PSD) is one of the main sub-detectors in the DArk Matter Particle Explorer (DAMPE) project. It will be operated over a large temperature range from -$10$ to $30^{\circ}$C, so the temperature effect of the…
Thermal effects are critical constrains for developing high-power thulium-doped fiber lasers (TDFLs). In this paper, we numerically investigate the lasing and thermal characteristics of the TDFLs under different pump transitions. Our…
Selective solar absorbers (SSAs) with high performance are the key to concentrated solar power systems. Optical metamaterials are emerging as a promising strategy to enhance selective photon absorption, however, the high-temperature…
Recent success in synthesizing thermally stable nanofluids at low costs is a significant breakthrough in the evolution of volumetric absorption based solar thermal systems. However, we have yet not been able to clearly identify the range of…
A systematic study was performed to measure the effective thermal conductivity of ceramic particle beds, a promising heat transfer and thermal energy storage media for concentrating solar power (CSP). The thermal conductivity of the ceramic…
The thermal lensing effects in the lasing crystal appear to be dominant when the pump laser focused on the lasing crystal which causes the local heating effect. The spatial refractive index variations observed if the crystal has non-uniform…