Related papers: Confinement controls the creep rate in soft granul…
The 2D flow of a foam confined in a Hele-Shaw cell through a contraction is investigated. Its rheological features are quantified using image analysis, with measurements of the elastic stress, rate of plasticity, and velocity. The behavior…
We report simulation results on melts of entangled linear polymers confined in a free-standing thin film. We study how the geometric constraints imposed by the confinement alter the entanglement state of the system compared to the…
Experimental measurements of the response of a two dimensional system of plastic beads subjected to steady shear are reported. The beads float at the surface of a fluid substrate and are subjected to a slow, steady-shear in a Couette…
When adhesive elastomeric materials slide over hard rough surfaces at low velocities, there are two primary dissipative mechanisms that control how friction changes with sliding velocity: viscoelastic dissipation and adhesive dissipation.…
We study the necking of a filament of complex fluid or soft solid subject to uniaxial tensile stretching, under conditions of constant imposed stress and force, by means of linear stability analysis and nonlinear simulations. We demonstrate…
The packing problem of long thin filaments that are injected into confined spaces is of fundamental interest for physicists and biologists alike. How linear threads pack and coil is well known only for the ideal case of rigid containers,…
We model the progressive maturation of a heterogeneous mass towards a gravity-driven instability, characterized by the competition between frictional sliding and tension cracking, using array of slider blocks on an inclined basal surface,…
The packing of elastic bodies has emerged as a paradigm for the study of macroscopic disordered systems. However, progress is hampered by the lack of controlled experiments. Here we consider a model experiment for the isotropic…
We systematically investigated the impact of boundary confinement on the shear-thickening rheology of dense granular suspensions. Under highly confined conditions, dense suspensions were found to exhibit size-dependent or even rarely…
The dramatic viscosity increase observed in dense suspensions under shear poses a major challenge in our understanding of how microscopic contact mechanics translate into macroscopic flow resistance. Here, we introduce a constraint-counting…
We study the outflow of soft particles through quasi-two-dimensional hoppers with both experiments and simulations. The experiments utilize spheres made with soft hydrogel, silicon rubber and glass. The hopper chamber has an adjustable exit…
Soft yet tough materials are ubiquitous in nature and everyday life. The ratio between fracture toughness and intrinsic fracture energy of a soft material defines its toughness enhancement. Soft materials' toughness enhancement has been…
Using experiments and simulations, we study the flow of soft particles through quasi-two-dimensional hoppers. The first experiment uses oil-in-water emulsion droplets in a thin sample chamber. Due to surfactants coating the droplets, they…
Shells, when confined, can deform in a broad assortment of shapes and patterns, often quite dissimilar to what is produced by their flat counterparts (plates). In this work we discuss the morphological landscape of shells deposited on a…
Granular materials such as sand, powders, and food grains are ubiquitous in civil engineering, geoscience, agriculture, and medicine. While the influence of friction between the grains on the static structure of these systems is well…
We investigate the flow of spherical, bulk granular particles down an inclined plane mixed with small-sized spherical lubricant particles using discrete element method simulations. Predefined cohesive interaction is implemented between…
Gravity-driven thick granular flows are relevant to many industrial and geophysical processes. In particular, it is important to know and understand the particle velocity distributions as we get deeper into the flow from the free surface.…
Plastic deformation in solids induced by external shear stress is of huge practical interest. Presence of local crystalline order in polycrystals, consisting of many grains, distinguishes its deformation pattern from that of amorphous…
Soft elastic sheets resting on rigid surfaces develop wrinkles, rucks, and folds due to the combined influence of elasticity, gravity, and contact interactions. Despite their ubiquity, the principles governing their morphology and…
We perform molecular dynamics simulations to characterize the occurrence of inhomogeneous shear flows in soft jammed materials. We use rough walls to impose a simple shear flow and study the athermal motion of jammed assemblies of soft…