Related papers: Towards Atomic MIMO Receivers
The capacity of a discrete-time multi-input multi-output (MIMO) Gaussian channel with output quantization is investigated for different receiver architectures. A general formulation of this problem is proposed in which the antenna outputs…
The utilization of radio frequency (RF) signals for wireless sensing has garnered increasing attention. However, the radio environment is unpredictable and often unfavorable, the sensing accuracy of traditional RF sensing methods is often…
This paper presents enhanced receiver metrics for joint estimation-detection in short blocklength transmissions, addressing scenarios with unknown channel state information and low or sparse training resource density. We show that it is…
Sensing and communication are fundamental enablers of next-generation networks. While communication technologies have advanced significantly, sensing remains limited to conventional parameter estimation and is far from fully explored.…
Massive multiple-input-multiple-output (M-MIMO) features a capability for spatial multiplexing of large number of users. This number becomes even more extreme in extra-large (XL-MIMO), a variant of M-MIMO where the antenna array is of very…
In this paper, a receiver algorithm consisting of differential transmission and a two-stage detection for a single-input multiple-output (SIMO) phase-noise channels is studied. Specifically, the phases of the QAM modulated data symbols are…
Intelligent reflecting surface (IRS) is a promising technology for the 6th generation of wireless systems, realizing the smart radio environment concept. In this paper, we present a novel tensor-based receiver for IRS-assisted…
This paper addresses the design of transmit precoder and receive combiner matrices to support $N_{\rm s}$ independent data streams over a time-division duplex (TDD) point-to-point massive multiple-input multiple-output (MIMO) channel with…
Classical, i.e. non-quantum, communications include configurations with multiple-input multiple-output (MIMO) channels. Some associated signal processing tasks consider these channels in a symmetric way, i.e. by assigning the same role to…
Large-scale multi-user multiple-input multiple-output (MU-MIMO) systems and cloud radio access networks (C-RANs) are considered promising technologies for the fifth generation (5G) of wireless networks. In these technologies, the use of…
The development of novel radio frequency atomic receivers brings attention to the theoretical description of atom-light interactions in sophisticated, multilevel schemes. Of special interest, are the schemes where several interaction paths…
Reconfigurable intelligent surfaces (RISs) have been introduced as a remedy for mitigating frequent blockages in millimeter wave (mmWave) multiple-input multiple-output (MIMO) communication networks. However, perfect or nearly perfect…
Massive MIMO is a compelling wireless access concept that relies on the use of an excess number of base-station antennas, relative to the number of active terminals. This technology is a main component of 5G New Radio (NR) and addresses all…
This paper proposes a Quantum-MUSIC, the first multiple signal classification (MUSIC) algorithm for quantum wireless sensing of multi-user. Since an atomic receiver for quantum wireless sensing can only measure the magnitude of a received…
Detection of signals buried in noise is the major challenge for sensing. Classically, the optimal detector is a matched filter, whose sensitivity meets the classical limit of correlation between the filter target and the measured signal…
Multiple-input multiple-output (MIMO) systems are required to communicate reliably at high spectral bands using a large number of antennas, while operating under strict power and cost constraints. In order to meet these constraints, future…
A quantum sensing protocol is proposed for demonstrating the motion-induced chirality of circularly polarised Rydberg atoms. To this end, a cloud of Rydberg atoms is dressed by a bichromatic light field. This allows to exploit the…
Reconfigurable Intelligent Surfaces (RISs) are regarded as a key technology for future wireless communications, enabling programmable radio propagation environments. However, the passive reflecting feature of RISs induces notable challenges…
In the massive machine-type communication (mMTC) scenario, a large number of devices with sporadic traffic need to access the network on limited radio resources. While grant-free random access has emerged as a promising mechanism for…
Linear minimum mean square error (LMMSE) receivers are often applied in practical communication scenarios for single-input-multiple-output (SIMO) systems owing to their low computational complexity and competitive performance. However,…