Related papers: Noise Suppression with Cryogenic Resonators
Cooling down test masses to cryogenic temperatures is a way to reduce the thermal noise of gravitational wave detectors. Crystalline materials are considered the most promising materials for fabricating cryogenic test masses and their…
A room temperature nuclear magnetic resonance force microscope (MRFM), fitted in a $^1$Tesla electromagnet, is used to measure the nuclear spin relaxation of $^1$H in a micron-size (70ng) crystal of ammonium sulfate. NMR sequences,…
We experimentally demonstrate the high-sensitivity optical monitoring of a micro-mechanical resonator and its cooling by active control. Coating a low-loss mirror upon the resonator, we have built an optomechanical sensor based on a very…
Pulse-tube based dilution refrigerators are massively employed in low temperature physics. They allow to reduce the running costs and to be operated with unprecedented easiness. However, the main drawback of this technology is the…
The discovery of superconductivity in the quantum critical Kondo-lattice system YbRh2Si2 at an extremely low temperature of 2 mK has inspired efforts to perform high-resolution electrical resistivity measurements down to this temperature…
We report a reduction of the frequency noise in coplanar waveguide superconducting resonators. The reduction of 7 dB is achieved by removing the exposed dielectric substrate surface from the region with high electric fields and by using…
The $\rm Fe_{1+y}Te_{1-x}Se_x$\ single crystals with the various Se/Te ratios were studied by the microwave absorption and direct current resistivity measurements. The comparison of the microwave absorption data and the resistivity versus…
The realization and characterization of a high quality factor resonator composed of two hollow-dielectric cylinders with its pseudo-TM$_{030}$ mode resonating at 10.9 GHz frequency is discussed. The quality factor was measured at the…
All quantum optomechanics experiments to date operate at cryogenic temperatures, imposing severe technical challenges and fundamental constraints. Here we present a novel design of on-chip mechanical resonators which exhibit fundamental…
Phonon modes at microwave frequencies can be cooled to their quantum ground state using conventional cryogenic refrigeration, providing a convenient way to study and manipulate quantum states at the single phonon level. Phonons are of…
We have measured noise in thin-film superconducting coplanar waveguide resonators. This noise appears entirely as phase noise, equivalent to a jitter of the resonance frequency. In contrast, amplitude fluctuations are not observed at the…
Time and frequency are the most accurately measurable quantities, providing foundations for science and modern technologies. The accuracy relies on the SI (Syst\'eme International) second that refers to Cs microwave clocks with fractional…
We demonstrate a high-Q ($>5 \times 10^{6}$) swept-frequency membrane mechanical resonator achieving octave resonance tuning via an integrated heater and an unprecedented acceleration noise floor below 1 $\mu$g Hz$^{-1/2}$ for frequencies…
This paper presents an ultra-low noise L-band radio astronomical cryogenic receiver for FAST telescope. The development of key low noise microwave parts of Coupling-LNA and conical quad-ridge OMT and reasonable system integration achieve…
Solid-state spin qubits have emerged as promising platforms for quantum information. Despite extensive efforts in controlling noise in spin qubit quantum applications, one important but less controlled noise source is near-field…
We describe the newest generation of the SLAC Microresonator RF (SMuRF) electronics, a warm digital control and readout system for microwave-frequency resonator-based cryogenic detector and multiplexer systems such as microwave SQUID…
Low mechanical loss materials are needed to further decrease thermal noise in upcoming gravitational wave detectors. We present an analysis of the contribution of Akhieser and thermoelastic damping on the experimental results of resonant…
We present the measurement of squeezed light generation using an engineered optomechanical system fabricated from a silicon microchip and composed of a micromechanical resonator coupled to a nanophotonic cavity. Laser light is used to…
Not all noise in experimental measurements is unwelcome. Certain fundamental noise sources contain valuable information about the system itself -- a notable example being the inherent voltage fluctuations that exist across any resistor…
We show that the internal quality factors of high impedance superconducting resonators made of granular aluminum can be improved by coating them with micrometric films of solid para-hydrogen molecular crystals. We attribute the average…