Related papers: SATDI: Simulation and Analysis for Time-Delay Inte…
Spaceborne gravitational wave observatories, exemplified by the Laser Interferometer Space Antenna (LISA) mission, are designed to remove laser noise and clock noise from interferometric phase measurements in postprocessing. The planned…
Tilts of certain elements within a laser interferometer can undesirably couple into measurements as a form of noise, known as tilt-to-length (TTL) coupling. This TTL coupling is anticipated to be one of the primary noise sources in the…
TianQin is a proposed space-borne gravitational wave (GW) observatory composed of three identical satellites orbiting around the geocenter with a radius of $10^5$ km. It aims at detecting GWs in the frequency range of 0.1 mHz -- 1 Hz. The…
A careful characterisation of the noise processes in pulsar timing data is a prerequisite for pulsar timing array experiments. While single-pulsar noise analyses are crucial for both gravitational-wave searches and astrophysical studies,…
In this article, which will appear as a chapter in the Handbook of Gravitational Wave Astronomy, we will describe the detection of gravitational waves with space-based interferometric gravitational wave observatories. We will provide an…
This document briefly describes the noise models and shapes used for the synthesis of the Drag-Free and Attitude Control System in the LISA space mission. LISA (Laser Interferometer Space Antenna) is one of the next large-class missions…
The Laser Interferometer Space Antenna (LISA) is a future space-based gravitational wave (GW) detector designed to be sensitive to sources radiating in the low frequency regime (0.1 mHz to 1 Hz). LISA's interferometer signals will be…
Interspacecraft ranging is crucial for the suppression of laser frequency noise via time-delay interferometry (TDI). So far, the effects of on-board delays and ambiguities on the LISA ranging observables were neglected in LISA modelling and…
Proper tuning of the orbital characteristics of the three spacecrafts that constitute the usual triangular configuration of the space-borne gravitational-wave detector LISA, could minimize the breathing mode of its arm-lengths. Since the…
High-precision interpolation of LISA phase measurements allows signal reconstruction and formulation of Time-Delay Interferometry (TDI) combinations to be conducted in post-processing. The reconstruction is based on phase measurements made…
LISA is the upcoming space-based Gravitational Wave telescope. LISA Pathfinder, to be launched in the coming years, will prove and verify the detection principle of the fundamental Doppler link of LISA on a flight hardware identical in…
The Laser Interferometer Space Antenna (LISA) aims to observe gravitational waves in the mHz regime over its 10-year mission time. LISA will operate laser interferometers between three spacecrafts. Each spacecraft will utilize independent…
TDI is essential in space-based GW detectors, effectively reducing laser noise and improving detection precision. Space-based GW detectors provide a unique opportunity to probe GW polarizations, including possible additional modes that may…
The orbiting LISA instrument is designed to detect gravitational waves in the millihertz band, produced by sources including galactic binaries and extreme mass ratio inspirals, among others. The detector consists of three spacecraft, each…
We previously showed how the measurements of some eighteen time series of relative frequency or phase shifts could be combined (1) to cancel the phase noise of the lasers, (2) to cancel the Doppler fluctuations due to non-inertial motions…
Variations in the instrumental noise of the Laser Interferometer Space Antenna (LISA) over time are expected as a result of e.g. scheduled satellite operations or unscheduled glitches. We demonstrate that these fluctuations can be leveraged…
The Laser Interferometer Space Antenna (LISA) mission aims to detect gravitational waves by interferometrically measuring the change of separation between free-falling test masses (TMs). LISA's interferometers must deliver pm/rtHz…
This paper presents a novel method for laser frequency stabilisation in the Laser Interferometer Space Antenna (LISA) mission by locking a laser to two stable length references - the arms of the interferometer and an on-board optical…
For the LISA mission, Tilt-To-Length (TTL) coupling is expected to be one of the dominant instrumental noise contributions after laser frequency noise is suppressed based, on assumptions on the size of the coupling and angular jitter…
A phase-locking configuration for LISA is proposed that provides a significantly simpler mode of operation. The scheme provides one Sagnac signal readout inherently insensitive to laser frequency noise and optical bench motion for a…