Related papers: Time-Varying Wireless Power Transfer Systems for I…
This paper studies a general multi-user wireless powered interference channel (IFC) under the harvest-then-transmit protocol, where the communication in channel coherence time consists of two phases, namely wireless energy transfer (WET)…
Simultaneous wireless information and power transfer (SWIPT) is an appealing solution to balance the energy distribution in wireless networks and improve the energy-efficiency of the entire network. In this paper, we study the optimal…
Simultaneous wireless information and power transfer (SWIPT) is a promising solution to increase the lifetime of wireless nodes and hence alleviate the energy bottleneck of energy constrained wireless networks. As an alternative to…
Wirelessly powered communications will entail short packets due to naturally small payloads, low-latency requirements and/or insufficient energy resources to support longer transmissions. In this paper, a wirelessly powered communication…
Powering mobiles using microwave \emph{power transfer} (PT) avoids the inconvenience of battery recharging by cables and ensures uninterrupted mobile operation. The integration of PT and \emph{information transfer} (IT) allows wireless PT…
Multicasting in wireless systems is a natural way to exploit the redundancy in user requests in a Content Centric Network. Power control and optimal scheduling can significantly improve the wireless multicast network's performance under…
In the context of implantable bioelectronics, this work provides new insights into maximizing biomedical wireless power transfer (BWPT) via the systematic development of inductive links. This approach addresses the specific challenges of…
Wireless power transfer (WPT) is a promising service for the Internet of Things, providing a cost-effective and sustainable solution to deploy so-called energy-neutral devices on a massive scale. The power received at the device side from a…
In this paper, we study a multi-sine multiple-input multiple-output (MIMO) wireless power transfer (WPT) system with the objective to increase the output DC power. We jointly optimize the multi-sine waveform and beamforming accounting for…
Talkative power conversion is a switching ripple communication technique that integrates data modulation into a switched-mode power electronics converter, enabling simultaneous information transmission and power conversion. Despite numerous…
We report preliminary results of a simulation study on the multi-hop extension of the recently-proposed energy-efficient wireless sensor network time synchronization scheme based on time-translating gateways. Unlike the single-hop case, in…
Waveform optimization has shown its great potential to boost the performance of far-field wireless power transfer (WPT). Current research has optimized transmit waveform, adaptive to channel state information (CSI), to maximize the…
Thermoelectric efficiency is defined as the ratio of power delivered to the load of a device to the rate of heat flow from the source. Till date, it has been studied in presence of thermodynamic constraints set by the Onsager reciprocal…
This work studies how to preemptively increase the resilience of a network by means of time-varying topological actuation. To do this, we focus on linear dynamical systems that are compatible with a given network, and consider policies that…
We show that a capacitive wireless power transfer device can be designed as a self-oscillating circuit using operational amplifiers. As the load and the capacitive wireless channels are part of the feedback circuit of the oscillator, the…
The low efficiency of far-field wireless power transfer (WPT) limits the fundamental rate-energy (R-E) performance trade-off of the simultaneous wireless information and power transfer (SWIPT) system. To address this challenge, we propose…
The problem of joint transfer of information and energy for wireless links has been recently investigated in light of emerging applications such as RFID and body area networks. Specifically, recent work has shown that the additional…
Series-parallel (SP) compensated wireless power transfer (WPT) systems are widely used in some specific scenarios, such as bioelectronics and portable electronics. However, most studies are based on the phasor method and focused on the…
The paper aims at demonstrating communication capabilities of IPT. For this data communication is performed between two modules using the concept of IPT. IPT was deemed to be the best solution to the system houses a multi parameter…
In this work, dynamic load modulation of high power amplifiers using a varactor-based tunable matching network is presented. The feasibility of dynamic tuning and efficiency enhancement of this technique is demonstrated using a modular…