Related papers: Asynchronous Distributed Coordinated Hybrid Precod…
In this paper, we propose a joint transceiver beamforming design to simultaneously mitigate self-interference (SI) and partial inter-node interference for full-duplex multiple-input and multiple-output ad-hoc network, and then derive the…
Medium-scale or large-scale receive antenna array with digital beamforming can be employed at receiver to make a significant interference reduction, but leads to expensive cost and high complexity of the RF-chain circuit. To deal with this…
In this letter, the maximization of resistible jamming power is studied for multi-user downlink millimeter-wave cell-free multiple-input-multiple-output (CF-MIMO) systems. We propose an alternate optimization-based anti-jamming hybrid…
To satisfy the capacity requirements of future mobile systems, under-utilized millimeter wave frequencies can be efficiently exploited by employing massive MIMO technology with highly directive beamforming. Hybrid analog-digital beamforming…
Cell-free massive multiple-input-multiple-output (CF-mMIMO) is regarded as one of the promising technologies for next-generation wireless networks. However, due to its distributed architecture, geographically separated access points (APs)…
Hybrid beamforming (HBF) transceiver architectures based on frequency-independent phase shifters (PS-HBF) are sensitive to the phases and physical directions with limited capability to compensate for the detrimental effects of the beam…
Hybrid beamforming is a promising technique to reduce the complexity and cost of massive multiple-input multiple-output (MIMO) systems while providing high data rate. However, the hybrid precoder design is a challenging task requiring…
High-mobility scenarios will be a critical part of 6G systems. Since the widely deployed orthogonal frequency division multiplexing (OFDM) waveform suffers from subcarrier orthogonality loss under severe Doppler spread, delay-Doppler domain…
Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Dynamic Metasurface Antennas (DMAs) constitute a promising solution for extremely large antenna arrays, requiring lower power consumption and reduced hardware cost as compared to conventional phased arrays. In this paper, we consider a…
In this paper, we propose a two-stage analog combining architecture for millimeter wave (mmWave) communications with hybrid analog/digital beamforming and low-resolution analog-to-digital converters (ADCs). We first derive a two-stage…
A multi-antenna broadcast channel scenario is considered where a base station delivers contents to cache-enabled user terminals. A joint design of coded caching (CC) and multigroup multicast beamforming is proposed to benefit from spatial…
Hybrid beamforming (HBF) design is a crucial stage in millimeter wave (mmWave) multi-user multi-input multi-output (MU-MIMO) systems. However, conventional HBF methods are still with high complexity and strongly rely on the quality of…
Dynamic Time Division Duplexing (D-TDD) allows cells to accommodate asymmetric traffic variations with high resource assignment flexibility. However, this feature is limited by two additional types of interference between cells in opposite…
Sub-terahertz (sub-THz) multi-user multiple-input multiple-output (MU-MIMO) systems unlock immense bandwidth for 6G wireless communications. However, practical deployment of wireless systems in sub-THz bands faces critical challenges such…
The joint design of analog beamforming and power allocation is investigated for a single radio-frequency chain multiuser time-division multiple access system under a max-min signal-to-noise ratio (SNR) criterion. A hardware-efficient…
The advancement of fifth generation (5G) wireless communication networks has created a greater demand for wireless resource management solutions that offer high data rates, extensive coverage, minimal latency and energy-efficient…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have been considered as one of the primary candidates for the fifth generation (5G) and beyond 5G wireless communication networks to satisfy the ever-increasing…
Random beamforming (RBF) is a practically favourable transmission scheme for multiuser multi-antenna downlink systems since it requires only partial channel state information (CSI) at the transmitter. Under the conventional single-cell…