Related papers: 3D Beamforming Through Joint Phase-Time Arrays
Phase-time arrays, which integrate phase shifters (PSs) and true-time delays (TTDs), have emerged as a cost-effective architecture for generating frequency-dependent rainbow beams in wideband sensing and localization. This paper proposes an…
The use of the millimeter (mm) wave spectrum for next generation (5G) mobile communication has gained significant attention recently. The small carrier wavelengths at mmwave frequencies enable synthesis of compact antenna arrays, providing…
In order to cope with the large path-loss exponent of mm-Wave channels, a high beamforming gain is needed. This can be achieved with small hardware complexity and high hardware power efficiency by Hybrid Digital-Analog (HDA) beamforming,…
Broadband beamforming is a technique to obtain the signal with a wide range of frequencies. It maintains the signal integrity and spatial selectivity over frequencies. This is important in several applications such as microphone array,…
For future mmWave mobile communication systems the use of analog/hybrid beamforming is envisioned be a key as- pect. The synthesis of beams is a key technology of enable the best possible operation during beamsearch, data transmission and…
Analog beamforming with phased arrays is a promising technique for 5G wireless communication in millimeter wave bands. A beam focuses on a small range of angles of arrival or departure and corresponds to a set of fixed phase shifts across…
In this correspondence, we propose a movable antenna (MA)-aided multi-user hybrid beamforming scheme with a sub-connected structure, where multiple movable sub-arrays can independently change their positions within different local regions.…
Hybrid beamforming for Terahertz (THz) ultra-massive multiple-input multiple-output (UM-MIMO) systems is a promising technology for 6G space-air-ground integrated networks, which can overcome huge propagation loss and offer unprecedented…
This paper studies a sub-connected six-dimensional movable antenna (6DMA)-aided multi-user communication system. In this system, each sub-array is connected to a dedicated radio frequency chain and collectively moves and rotates as a unit…
Communication systems at millimeter-wave (mmW) and sub-terahertz frequencies are of increasing interest for future high-data rate networks. One critical challenge faced by phased array systems at these high frequencies is the efficiency of…
Spatially structured beams have emerged as a promising technology for enhancing spectrum efficiency (SE) in sixth-generation (6G) networks. However, structured beam schemes based on fixed-position antennas (FPAs) fail to fully exploit the…
Phased arrays, commonly used in IEEE 802.11ad and 5G radios, are capable of focusing radio frequency signals in a specific direction or a spatial region. Beamforming achieves such directional or spatial concentration of signals and enables…
Reconfigurable antenna technology, such as movable antennas (MAs) and rotatable antennas (RAs), has emerged as a promising solution to enhance the communication performance of wireless systems by exploiting the new degree of freedom (DoF)…
The quest for higher wireless carrier frequencies spanning the millimeter-wave (mmWave) and Terahertz (THz) bands heralds substantial enhancements in data throughput and spectral efficiency for next-generation wireless networks. However,…
Dynamic metasurface antennas (DMA) provide low-power beamforming through reconfigurable radiative slots. Each slot has a tunable component that consumes low power compared to typical analog components like phase shifters. This makes DMAs a…
Transmit beamforming is a versatile technique for signal transmission from an array of $N$ antennas to one or multiple users [1]. In wireless communications, the goal is to increase the signal power at the intended user and reduce…
Two beam broadening methods for active electronically scanned array (AESA) antennas with uniform amplitude excitation are proposed and compared: phase tapering optimization (PTO) and a novel time-varying phase tapering (TPT). The PTO is a…
We propose an efficient method for designing broad beams with spatially flat array factor and efficient power utilization for cell-specific coverage in communication systems equipped with large antenna arrays. To ensure full power…
The position-fluid antenna (PFA) architecture has become one of the appealing technologies to support ubiquitous connectivity demand in next-generation wireless systems. Specifically, allowing the antenna to adjust its physical position to…
Conventional multi-beam forming with fixed-position antenna (FPA) arrays needs to trade-off between maximizing the beamforming gain over desired directions and minimizing the interference power over undesired directions. In this letter, we…