Related papers: A Configurable Ultra-Low Noise Current Source for …
In this paper, we present a programmable Ultra Low DC Current Source (ULCS) developed at T\"UB\.ITAK UME. The output current range is from 1 fA up to 100 pA with 100 aA resolution and is directly traceable to DC voltage, capacitance and…
Far-infrared Transition Edge Sensors (TESs) are being developed for the SAFARI grating spectrometer on the cooled-aperture space telescope SPICA. In support of this work, we have devised a cryogenic (90 mK) test facility for carrying out…
The HOLMES experiment will perform a precise calorimetric measurement of the end point of the Electron Capture (EC) decay spectrum of 163Ho in order to extract information on neutrino mass with a sensitivity below 2 eV. In its final…
The SuperCDMS experiment implements transition-edge sensors to measure athermal phonons produced by nuclear recoils in Ge crystals. We discuss a numerical simulation of these TES devices and a procedure for tuning the free model parameters…
Superconducting detectors are now well-established tools for low-light optics, and in particular quantum optics, boasting high-efficiency, fast response and low noise. Similarly, lithium niobate is an important platform for integrated…
Unsupervised Change Detection (UCD) in multimodal Remote Sensing (RS) images remains a difficult challenge due to the inherent spatio-temporal complexity within data, and the heterogeneity arising from different imaging sensors. Inspired by…
Diffuse correlation spectroscopy (DCS) is an emerging noninvasive technique that measures the tissue blood flow, by using near-infrared coherent point-source illumination to detect spectral changes. While machine learning has demonstrated…
We present the design and test results of a Time-to-Digital-Converter (TDC). The TDC will be a part of the readout ASIC, called ETROC, to read out Low-Gain Avalanche Detectors (LGADs) for the CMS Endcap Timing Layer (ETL) of High-Luminosity…
CMOS detectors offer many advantages over CCDs for optical and UV astronomical applications, especially in space where high radiation tolerance is required. However, astronomical instruments are most often designed for low light-level…
Transition-edge sensor (TES) bolometers are broadly used for background-limited astrophysical measurements from the far-infrared to mm-waves. Many planned future instruments require increasingly large detector arrays, but their scalability…
We have fabricated Transition Edge Sensors (TESs) whose thermal characteristics are completely characterised by few-mode ballistic phonon exchange with the heat bath. These TESs have extremely small amorphous SiNx support legs: 0.2 um…
In our work, we have engineered low capacitance single quantum dot photodiodes as sensor devices for the optoelectronic sampling of ultrafast electric signals. By the Stark effect, a time-dependent electric signal is converted into a…
The Low Energy Neutron Source (LENS) is an accelerator-based pulsed cold neutron facility under construction at the Indiana University Cyclotron Facility (IUCF). The idea behind LENS is to produce pulsed cold neutron beams starting with…
We introduce a machine-learning-based approach to enhance the sensitivity of optical-extreme ultraviolet (XUV) transient absorption spectroscopy. A reference spectrum is used as input to a three-layer feed-forward neural network, allowing…
The quantum rectification effect observed on asymmetric superconducting loops is proposed to use as a basic of a noise detector with maximum sensitivity. The measurements show that a critical amplitude of noise or ac current decreases down…
We describe a process route to fabricate arrays of Ultra-low-Noise MoAu Transition Edge Sensors (TESs). The low thermal conductance required for space applications is achieved using 200 nm-thick Silicon Nitride (SiNx ) patterned to form…
We demonstrate a sub-shot-noise-limit discrimination of on-off keyed coherent signals by an optimal displacement quantum receiver in which a superconducting transition edge sensor is installed. Use of a transition edge sensor and a fiber…
Digital correlated double sampling (DCDS), a readout technique for charge-coupled devices (CCD), is gaining popularity in astronomical applications. By using an oversampling ADC and a digital filter, a DCDS system can achieve a better…
Background and Objective: Transcranial temporal interference stimulation (tTIS) is a promising non-invasive brain stimulation technique in which interference between electrical current fields extends the possibilities of electrical brain…
We present a femtosecond time-resolved optical spectroscopy (TRS) as an experimental tool to probe the changes in the low energy electronic density of states as a result of short and long range charge density wave order. In these…