Related papers: HARQ-IR Aided Short Packet Communications: BLER An…
As opposed to hybrid automatic repeat request with incremental redundancy (HARQ-IR) that all the resources are occupied to resend the redundant information, cross-packet HARQ (XP-HARQ) allows the introduction of new information into…
Hybrid Automatic ReQuest (HARQ) protocol enables reliable communications in wireless systems. Usually, several parallel streams are sent in successive timeslots following a time-sharing approach. Recently, multi-layer HARQ has been proposed…
This paper investigates the usage of hybrid automatic repeat request (HARQ) protocols for power-efficient and reliable communications over free space optical (FSO) links. By exploiting the large coherence time of the FSO channel, the…
In many wireless systems, the signal-to-interference-and-noise ratio that is applicable to a certain transmission, referred to as channel state information (CSI), can only be learned after the transmission has taken place and is thereby…
The trade-off between reliability, latency, and energy efficiency is a central problem in communication systems. Advanced hybrid automated repeat request (HARQ) techniques reduce retransmissions required for reliable communication but incur…
This paper investigates the ultra reliable and low latency communication (URLLC) performance of the IRS-aided MIMO system. The upper and lower bounds of the optimal average error probability (OAEP) for the coding rate 1/sqrt(Mn) of the…
In this work, we consider the problem of network parameter optimization for rate maximization. We frame this as a joint optimization problem of power control, beam forming, and interference cancellation. We consider the setting where…
Bit error rate (BER) minimization and SNR-gap maximization, two robustness optimization problems, are solved, under average power and bit-rate constraints, according to the waterfilling policy. Under peak-power constraint the solutions…
Mechanisms for data recovery and packet reliability are essential components of the upcoming 6th generation (6G) communication system. In this paper, we evaluate the interaction between a fast hybrid automatic repeat request (HARQ) scheme,…
End-to-end learning of communications systems is a fascinating novel concept that has so far only been validated by simulations for block-based transmissions. It allows learning of transmitter and receiver implementations as deep neural…
This paper studies the performance of hybrid-ARQ (automatic repeat request) in Rayleigh block fading channels. The long-term average transmitted rate is analyzed in a fast-fading scenario where the transmitter only has knowledge of channel…
Hybrid Automatic Repeat Request (HARQ) schemes typically allocate all available resources to retransmit failed packets to ensure reliability. However, under stringent delay constraints, these schemes often exhibit low spectral efficiency…
In this work, we propose a coding strategy designed to enhance the throughput of hybrid ARQ (HARQ) transmissions over i.i.d. block-fading channels with the channel state information (CSI) unknown at the transmitter. We use a joint packet…
In this paper, energy efficiency of hybrid automatic repeat request (HARQ) schemes with statistical queuing constraints is studied for both constant-rate and random Markov arrivals by characterizing the minimum energy per bit and wideband…
Automatic repeat request (ARQ) is widely used in modern communication systems to improve transmission reliability. In conventional ARQ protocols developed for systems with energy-unconstrained receivers, an…
In this work, we consider transmissions over block fading channels and assume that adaptive modulation and coding (AMC) and hybrid automatic repeat request (HARQ) are implemented. Knowing that in high signal-to-noise ratio, the conventional…
Future 5G cellular networks supporting ultra-reliable, low-latency communications (URLLC) could employ random access communication to reduce the overhead compared to scheduled access techniques used in 4G networks. We consider a wireless…
In this paper, the average achievable rate of a re-configurable intelligent surface (RIS) aided factory automation is investigated in finite blocklength (FBL) regime. First, the composite channel containing the direct path plus the product…
Assuming noisy feedback channels, this paper investigates the data transmission efficiency and robustness of different automatic repeat request (ARQ) schemes using adaptive power allocation. Considering different block-fading channel…
We study incremental redundancy hybrid ARQ (IR-HARQ) schemes based on punctured, finite-length, LDPC codes. The transmission is assumed to take place over time varying binary erasure channels, such as mobile wireless channels at the…