Related papers: Microstructure evolution of carbon films with incr…
The copper ferrite thin films have been deposited by RF sputtering at a 50W rf power. The As-deposited films are annealed in air at $800^{\circ}$C and then slow cooled. The As-deposited (AD) as well as slow cooled (SC) films are studied…
We perform in-situ two-cycle thermal cycling and annealing studies for a transferred CVD-grown monolayer MoS2 on a SiO2/Si substrate, using spatially resolved micro-Raman and PL spectroscopy. After the thermal cycling and being annealed at…
In situ growth of pyrochlore iridate thin films has been a long-standing challenge due to the low reactivity of Ir at low temperatures and the vaporization of volatile gas species such as IrO3(g) and IrO2(g) at high temperatures and high…
We synthesize large-area graphene via atmospheric-pressure (AP) chemical vapor deposition (CVD) on copper, and transfer to SiO2 wafers. In contrast to low-pressure (LP) CVD on copper, optical contrast and atomic force microscopy…
Plasma surface modification was used to fabricate graphene on the top of insulating diamond-like carbon films. It is shown that by a combination of pulsed argon plasma treatment and thermal annealing at 350\degreeC is possible to achieve…
The stationary thermal state and propagation of a normal zone in a long superconducting film on a wide substrate are analyzed analytically. Expressions describing voltage-current characteristics and temperature-current dependence of the…
Zinc sulfide ZnS thin films with variable structural, optical, electrical, and thermoelectric properties were obtained by changing the source to substrate SSD distance in the physical vaporthermal coating PVTC system. The films crystallized…
In this work, we investigate the correlation between morphology, composition, and the mechanical properties of metallic amorphous tungsten-oxygen and amorphous tungsten-oxide films deposited by Pulsed Laser Deposition. This correlation is…
The effects of Mg deficiency in MgB2 films grown by using hybrid physical-chemical vapor deposition were investigated after vacuum annealing at various temperatures. High-quality MgB2 films grown on c-cut Al2O3 substrates with different…
Chemical vapor deposition (CVD) is a widely used technique to grow solid materials with accurate control of layer thickness and composition. Under mass-transport-limited conditions, the surface of thin films thus produced grows in an…
We investigated optical absorption coefficient spectra of an epitaxial VO2 film in wide photon energy (0.5 - 5.0 eV) and temperature (100 - 380 K) regions. In its insulating phase, we observed two d-d transition peaks around 1.3 eV and 2.7…
By molecular dynamics simulation, the chemical vapor deposition of amorphous carbon onto graphite and diamond surfaces was studied. In particular, we investigated the effect of source H/C ratio, which is the ratio of the number of hydrogen…
We report the temperature evolution of the Dirac band in semiconducting zirconium pentatelluride (ZrTe$_5$) using magneto-infrared spectroscopy. We find that the band gap is temperature independent at low temperatures and increases with…
The influence of SiC-impurity layer and growth temperature on microstructure and superconducting properties were studied for MgB2 superconducting tapes. The pulsed laser deposition (PLD) system was used for the deposition of amorphous…
We investigate the microscopic processes leading to graphene growth by the chemical vapor deposition of propane in the argon atmosphere at the SiC surface. Experimentally, it is known that the presence of argon fastens the dehydrogenation…
Entropy stabilization has garnered significant attention as a new approach to designing novel materials. Much of the work in this area has focused on bulk ceramic processing, leaving entropy-stabilized thin films relatively underexplored.…
Thin films of superconducting V$_3$Si were prepared by means of RF sputtering from a compound V$_3$Si target at room temperature onto sapphire and oxide-coated silicon wafers, followed by rapid thermal processing under secondary vacuum. The…
We present temperature dependent frequency shift and line broadening of phonon modes by insertion of atomic layers of Pb and PbTe in the prototype 3D topological insulator Bi2Te3, using Raman spectroscopy. Good quality single crystals of…
Herein, an effort has given to sheds light on the effects of plasma process parameters on the growth of vertical graphene nanosheets (VGNs) by plasma enhanced chemical vapor deposition (PECVD. The parameters include substrate temperature,…
High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature…