Related papers: Multi-dimensional Energy Limitation in Sphere Shap…
Fifth generation (5G) and beyond communication systems open the door to millimeter Wave (mmWave) frequency bands to leverage the extremely large operating bandwidths and deliver unprecedented network capacity. These frequency bands are…
Utilizing the multi-dimensional (MD) space for constellation shaping has been proven to be an effective approach for achieving shaping gains. Despite there exists a variety of MD modulation formats tailored for specific optical transmission…
The capacity of commercial massive multiple-input multiple-output (mMIMO) systems is constrained by the limited array aperture at the base station, and cannot meet the ever-increasing traffic demands of wireless networks. Given the array…
In this paper, we present a non-coherent energy detection scheme for spatial modulation (SM) systems. In particular, the use of SM is motivated by its low-complexity implementation in comparison to multiple-input multiple-output (MIMO)…
This letter revisits the equal-gain (EG) spatial diversity technique, which was proposed to combat the human-induced shadowing for 60 GHz wireless local area network, under a more practical frequency-selective multi-input multi-output…
Nonlinear precoding and pulse shaping are jointly considered in multi-user massive multiple-input multiple-output (MIMO) systems with low-resolution D/A-converters (DACs) in terms of algorithmic approach as well as large system performance.…
Two novel 5.5 bit/4D modulation formats are experimentally demonstrated to transmit over 9680 km of SSMF. A reach increase of 29.4% over the 6 bit/4D PM-8QAM is shown. Furthermore, increased nonlinear tolerance with respect to PM-8QAM is…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) with hybrid precoding is a promising technique for the future 5G wireless communications. Due to a large number of antennas but a much smaller number of radio frequency…
We propose and model an optical communication scheme for short distance datacom links based on the distribution of information across a wide comb spectrum. This modulation format, orthogonal delay division multiplexing, allows the…
This letter describes how to improve performance of cellular systems by combining non-equiprobable signaling (shaping) with low-density parity check (LDPC) coding for an orthogonal frequency division multiplexing system. We focus on…
This paper proposes a general optimization framework to improve the spectral and energy efficiency (EE) of ultra-reliable low-latency communication (URLLC) simultaneous-transfer-and-receive (STAR) reconfigurable intelligent surface…
In this letter, we investigate time-domain channel estimation for wideband millimeter wave (mmWave) MIMO OFDM system. By transmitting frequency-domain pilot symbols as well as different beamforming vectors, we observe that the time-domain…
The rate flexibility and probabilistic shaping gain of $4$-dimensional signaling is experimentally tested for short-reach, unrepeated transmission. A rate granularity of 0.5 bits/QAM symbol is achieved with a distribution matcher based on a…
After reviewing models and mitigation strategies for interchannel nonlinear interference (NLI), we focus on the frequency-resolved logarithmic perturbation model to study the coherence properties of NLI. Based on this study, we devise an…
Circularly pulse-shaped orthogonal frequency division multiplexing (CPS-OFDM) is one of the most promising 5G waveforms that addresses two physical layer signal requirements of low out-of-subband emission (OSBE) and low peak-to-average…
Optoelectronic systems based on multiple modes of light can often exceed the performance of their single-mode counterparts. However, multimode nonlinear interactions often introduce considerable amounts of noise, limiting the ultimate…
Millimeter-wave (mmWave) communication systems require narrow beams to increase communication range. If the dominant communication direction is blocked by an obstacle, an alternative and reliable spatial communication path should be quickly…
Single photon emitters (SPEs) are building blocks of quantum technologies. Defect engineering of 2D materials is ideal to fabricate SPEs, wherein spatially deterministic and quality-preserving fabrication methods are critical for…
Massive multiple-input multiple-output (MIMO) techniques have been recently advanced to tremendously improve the performance of wireless communication networks. However, the use of very large antenna arrays at the base stations (BSs) brings…
Two signal multiplexing schemes for optical fiber communication are considered: Wavelength-division multiplexing (WDM) and nonlinear frequency-division multiplexing (NFDM), based on the nonlinear Fourier transform (NFT). Achievable…