Related papers: Phase noise of a microwave photonic channel: direc…
The microwave signal at the output of a photodiode that detects a modulated optical beam contains the phase noise phi(t) and the amplitude noise alpha(t) of the detector. Beside the white noise, which is well understood, the spectral…
We present an optical frequency divider based on a 200 MHz repetition rate Er:fiber mode-locked laser that, when locked to a stable optical frequency reference, generates microwave signals with absolute phase noise that is equal to or…
Understanding the amplifier phase noise is a critical issue in numerous fields of engineering and physics, like oscillators, frequency synthesis, telecommunications, radars, spectroscopy, in the emerging domain of microwave photonics, and…
The generation of microwaves from optical signals suffers from thermal and shot noise inherent in the photodetection process. This problem is more acute at lower pulse repetition rates where photodiode saturation limits the achievable…
Phase noise can be modulated onto the output of a laser with an electro-optic phase modulator (EOM) to create a highly incoherent broadened source with low intensity noise. This technique leaves a small but finite fraction of the coherent…
We demonstrate ultralow phase noise 10-GHz microwave signal generation from a free-running mode-locked Er-fiber laser with -142 and -157 dBc/Hz single-sideband absolute phase noise at 10- and 100-kHz offset frequencies, respectively. The…
We investigate the impact of pulse interleaving and optical amplification on the spectral purity of microwave signals generated by photodetecting the pulsed output of an Er:fiber-based optical frequency comb. It is shown that the microwave…
For coherent and direct-detection Orthogonal Frequency Division Multiplexed (OFDM) systems employing radio frequency (RF) pilot tone phase noise cancellation the influence of laser phase noise is evaluated. Novel analytical results for the…
We report on the characterization of a commercial-core fiber-based frequency comb equipped with an intracavity electro-optic modulator (EOM). We investigate the relationship between the noise of the pump diode and the laser relative…
We demonstrate an amplitude-to-phase (AM-PM) conversion coefficient for a balanced optical-microwave phase detector (BOM-PD) of 0.001 rad, corresponding to AM-PM induced phase noise 60 dB below the single-sideband relative intensity noise…
We synchronize a 8.06-GHz microwave signal from a voltage-controlled oscillator with an optical pulse train from a 77.5- MHz mode-locked Er-fiber laser using a fiber-based optical-microwave phase detector. The residual phase noise between…
Cavity opto-mechanical cooling via radiation pressure dynamical backaction enables ground state cooling of mechanical oscillators, provided the laser exhibits sufficiently low phase noise. Here, we investigate and measure the excess phase…
Lasers are the workhorse of quantum engineering in the atomic-molecular-optic community. However, phase noise of the laser, which can be especially large in popular semiconductor-based lasers, can limit fidelity of operation. Here, we…
The performance of laser-based active sensing has been severely limited by two types of noise: electrical noise, stemming from elements; optical noise, laser jamming from an eavesdropper and background from environment. Conventional methods…
Laser phase noise remains a limiting factor in many experimental settings, including metrology, time-keeping, as well as quantum optics. Hitherto this issue was addressed at low frequencies, ranging from well below 1 Hz to maximally 100…
Photonic-based low-phase-noise microwave generation with real-time frequency tuning is crucial for a broad spectrum of subjects, including next-generation wireless communications, radar, metrology, and modern instrumentation. Here, for the…
Direct phase modulation via optical injection is a newly developed method for coding the phase of a gain-switched laser, which meets high requirements placed on transmitters for quantum key distribution: compactness, low losses,…
We reduce the intensity noise of laser light by using an electro-optic modulator and a cousto-optic modulator in series. The electro-optic modulator reduces noise at high frequency(10 kHz to 1 MHz), while the acousto-optic modulator sets…
We introduce a novel measurement method for the phase noise measurement of optical amplifiers, topologically similar to the Heterodyne Mach-Zehnder Interferometer but governed by different principles, and we report on the measurement of a…
As a consequence of a general trend in the physics of oscillators and clocks towards optics, phase and frequency metrology is rapidly moving to optics too. Yet, optics is not replacing the traditional radio-frequency (RF) and microwave…