Related papers: Monitoring TES Loop Gain in Frequency Multiplexed …
This paper introduces a novel beam tracking scheme for full-duplex ground user terminals aiming to transmit uplink and receive downlink from two low Earth orbit (LEO) satellites at the same time and same frequency. Our proposed technique…
Measurement-based feedback control is central in quantum computing and precise quantum control. Here we realize a fast and flexible field-programmable-gate-array-based feedback control in a superconducting Xmon qubit system. The latency of…
Suppression of beam losses is essential for successful operation of high-intensity linac. Historically, the values of the field amplitudes and phases of the side-coupled, 805-MHz LANSCE linac modules are maintained using a well-known…
Transition-edge sensors (TES) as microcalorimeters for high-energy-resolution X-ray spectroscopy are often fabricated with an absorber made of materials with high Z (for X-ray stopping power) and low heat capacity (for high resolving…
Intelligent reflecting surface (IRS) is a promising technology to boost the efficiency of wireless energy transfer (WET) systems. However, for a multiuser WET system, simultaneous multi-beam energy transmission is generally required to…
This paper addresses the stability and $\ell^2$-gain analysis of adaptive control systems with event-triggered try-once-discard protocols. At every sampling time, an event trigger evaluates an error between the current value and the last…
The prototype of time digitizing system for the upgrade of BESIII endcap TOF (ETOF) is introduced in this paper. The ETOF readout electronics has a formation of distributed architecture that hit signal from multi-gap resistive plate chamber…
We have designed and demonstrated a Superconducting Quantum Interference Device (SQUID) array linearized with cryogenic feedback. To achieve the necessary loop gain a 300 element series array SQUID is constructed from three monolithic…
This chapter focuses on a hardware architecture for semi-passive Reconfigurable Intelligent Surfaces (RISs) and investigates its consideration for boosting the performance of Multiple-Input Multiple-Output (MIMO) communication systems. The…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
LTE evolved Multimedia Broadcast/Multicast Service (eMBMS) is an attractive solution for video delivery to very large groups in crowded venues. However, deployment and management of eMBMS systems is challenging, due to the lack of realtime…
In electrically substituted radiometers, the ultra low noise control of the temperature is required. In this framework, we present results dedicated to the temperature regulation of copper plates, 3 cm diameter and 1 mm thick, using…
This paper presents the design and implementation of the front-end electronics and the data acquisition (DAQ) system for readout of multi-wire drift chambers (MWDC). Apart of the conventional drift time measurement the system delivers the…
We report on the piezoresistive method for detecting stability loss events in microelectromechanical (MEMS) sensors based on bifurcation. The method involves measuring the resistivity changes of an entire beam to detect snap-through…
In this paper, we discuss various topological and metrical aspects of the set of stabilizing static feedback gains for multiple-input-multiple-output (MIMO) linear-time-invariant (LTI) systems, in both continuous and discrete-time.…
The state-of-the-art technology of X-ray microcalorimeters based on superconducting transition edge sensors (TESs), for applications in astrophysics and particle physics, is reviewed. We will show the advance in understanding the detector…
In this article, an efficient transient electricalthermal co-simulation method based on the finite element method (FEM) and the discontinuous Galerkin time-domain (DGTD) method is developed for electrical-thermal coupling analysis of…
Measurement-based control, utilizing an active feedback loop, is a standard tool in technology. Feedback control is also emerging as a useful and fundamental tool in quantum technology and in related fundamental studies, where it can be…
This paper presents performance measurements of a new readout electronics system based on silicon photomultipliers for the PHENIX electromagnetic calorimeter. Installation of the lead-scintillator Shashlik style calorimeter into the…
We present a detailed thermal and electrical model of superconducting transition edge sensors (TESs) connected to quasiparticle (qp) traps, such as the W TESs connected to Al qp traps used for CDMS (Cryogenic Dark Matter Search) Ge and Si…