Related papers: Low Overhead Beam Alignment for Mobile Millimeter …
Orbital angular momentum (OAM) at radio frequency (RF) has attracted more and more attention as a novel approach of multiplexing a set of orthogonal OAM modes on the same frequency channel to achieve high spectral efficiency (SE). However,…
We propose an intuitive, simple and hardware friendly, yet surprisingly novel and efficient, received signal's angle of arrival (AoA) estimation scheme. Our intuitive, two-phases cross-correlation based scheme relies on a switched beam…
In the advent of next-generation wireless communication, millimeter-wave (mmWave) and terahertz (THz) technologies are pivotal for their high data rate capabilities. However, their reliance on large antenna arrays and narrow directive beams…
Efficient beam alignment is a crucial component in millimeter wave systems with analog beamforming, especially in fast-changing vehicular settings. This paper proposes a position-aided approach where the vehicle's position (e.g., available…
Beam management, including initial access (IA) and beam tracking, is essential to the millimeter-wave Unmanned Aerial Vehicle (UAV) network. However, conventional communication-only and feedback-based schemes suffer a high delay and low…
Wireless backhaul communication has been recently realized with large antennas operating in the millimeter wave (mmWave) frequency band and implementing highly directional beamforming. In this paper, we focus on the alignment problem of…
In this paper, adaptive pilot beam sequence design for channel estimation in large millimeter-wave (mmWave) MIMO systems is considered. By exploiting the sparsity of mmWave MIMO channels with the virtual channel representation and imposing…
Beamforming-capable antenna arrays with many elements enable higher data rates in next generation 5G and 6G networks. In current practice, analog beamforming uses a codebook of pre-configured beams with each of them radiating towards a…
Beamforming techniques are considered as essential parts to compensate severe path losses in millimeter-wave (mmWave) communications. In particular, these techniques adopt large antenna arrays and formulate narrow beams to obtain…
In this paper, a low complexity time domain semi-blind algorithm is proposed to estimate and track the time varying MIMO OFDM channels. First, the proposed least mean squares (LMS) based algorithm is developed for the training mode and then…
Fast and precise beam alignment is crucial for high-quality data transmission in millimeter-wave (mmWave) communication systems, where large-scale antenna arrays are utilized to overcome the severe propagation loss. To tackle the…
Millimeter-wave (mmWave) and terahertz (THz) communication systems typically deploy large antenna arrays to guarantee sufficient receive signal power. The beam training overhead associated with these arrays, however, make it hard for these…
Channel prediction compensates for outdated channel state information in multiple-input multiple-output (MIMO) systems. Machine learning (ML) techniques have recently been implemented to design channel predictors by leveraging the temporal…
This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…
Millimeter wave (mmWave) communication, utilizing beamforming techniques to address the inherent path loss limitation, is considered as one of the key technologies to support ever increasing high throughput and low latency demands of…
Movable antenna (MA) technology offers promising potential to enhance wireless communication by allowing flexible antenna movement. To maximize spatial degrees of freedom (DoFs), larger movable regions are required, which may render the…
Beamforming is a signal processing technique where an array of antenna elements can be steered to transmit and receive radio signals in a specific direction. The usage of millimeter wave (mmWave) frequencies and multiple input multiple…
This paper studies a multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) networked integrated sensing and communication (ISAC) system, in which multiple base stations (BSs) perform beam tracking to…
In this paper, beam training and beam tracking are investigated for extremely large-scale multiple-input-multiple-output communication systems with partially-connected hybrid combining structures. Firstly, we propose a two-stage…
This paper presents the first large-scale real-world evaluation for using LiDAR data to guide the mmWave beam prediction task. A machine learning (ML) model that leverages the LiDAR sensory data to predict the current and future beams was…