Related papers: A Lightweight Routing Layer Using a Reliable Link-…
Ultra-reliability and low-latency are two key components in 5G networks. In this letter, we investigate the problem of ultra-reliable and low-latency communication (URLLC) in millimeter wave (mmWave)-enabled massive multiple-input…
Seamless redundancy can be profitably exploited to improve predictability of wireless networks in general and, in particular, IEEE 802.11. According to this approach, packets are transmitted by senders on two (or more) channels at the same…
Packet scheduling is a fundamental networking task that recently received renewed attention in the context of programmable data planes. Programmable packet scheduling systems such as those based on Push-In First-Out (PIFO) abstraction…
Emerging interconnects, such as CXL and NVLink, have been integrated into the intra-host topology to scale more accelerators and facilitate efficient communication between them, such as GPUs. To keep pace with the accelerator's growing…
Cost-effective embedded systems necessitate utilizing the single-wire communication protocol for inter-chip communication, thanks to its reduced pin count in comparison to the multi-wire I2C or SPI protocols. However, current single-wire…
Driven by the special requirements of the Lowpower and Lossy Networks (LLNs), the IPv6 Routing Protocol for LLNs (RPL) was standardized by the IETF some six years ago to tackle the routing issue in such networks. Since its introduction,…
We consider transport layer approaches for achieving high rate, low delay communication over edge paths where the bottleneck is an 802.11ac WLAN. We first show that by regulating send rate so as to maintain a target aggregation level it is…
Federated learning (FL) is a promising paradigm that enables collaboratively learning a shared model across massive clients while keeping the training data locally. However, for many existing FL systems, clients need to frequently exchange…
Advanced industrial applications for human-machine interaction such as augmented reality support for maintenance works or mobile control panels for operating production facility set high demands on underlying wireless connectivity solution.…
RPL, an IPv6 routing protocol for Low power Lossy Networks (LLNs), is considered to be the de facto routing standard for the Internet of Things (IoT). However, more and more experimental results demonstrate that RPL performs poorly when it…
Random Linear Network Coding (RLNC) has emerged as a powerful tool for robust high-throughput multicast. Projection analysis - a recently introduced technique - shows that the distributed packetized RLNC protocol achieves (order) optimal…
The deployment of machine learning algorithms on resource-constrained edge devices is an important challenge from both theoretical and applied points of view. In this article, we focus on resource-efficient randomly connected neural…
Densification of the network deployment, for example by adding new sectors or sites within an existing mobile communication network, has traditionally been an efficient way to improve the system coverage and capacity. That will be the case…
This paper considers reliable data transfer in a high-speed network (HSN) in which the per-connection capacity is very large. We focus on sliding window protocols employing selective repeat for reliable data transfer and study two…
Minimal infrastructure requirements make LoRa suitable for service delivery in remote areas. Additionally, web applications have become a de-facto standard for modern service delivery. However, Long Range (LoRa) fails to enable HTTP access…
Low-power and lossy networks (LLNs) enable diverse applications integrating many resource-constrained embedded devices, often requiring interconnectivity with existing TCP/IP networks as part of the Internet of Things. But TCP has received…
The increasing proliferation of Internet of Things (IoT) devices has created a growing need for more efficient communication networks, especially in areas where continuous connectivity is unstable or unavailable. Opportunistic networks have…
This paper considers the use of routerless networks-on-chip as an alternative on-chip interconnect for multiprocessor systems requiring hard real-time guarantees for inter-processor communication. It presents a novel analytical framework…
This paper considers a communication network comprised of two nodes, which have no mutual direct communication links, communicating two-way with the aid of a common relay node (RN), also known as separated two-way relay (TWR) channel. We…
The strict latency and reliability requirements of ultra-reliable low-latency communications (URLLC) use cases are among the main drivers in fifth generation (5G) network design. Link adaptation (LA) is considered to be one of the…