Related papers: Metallised 3D printed plastic resonator demonstrat…
The microwave properties of a crystalline sapphire dielectric whispering gallery mode resonator have been measured at very low excitation strength (E/hf=1) and low temperatures (T = 30 mK). The measurements were sensitive enough to observe…
As superconducting kinetic inductance detectors (KIDs) continue to grow in popularity for sensitive submillimeter detection and other applications, there is a drive to advance toward lower-loss devices. We present measurements of diagnostic…
Superconductivity has been one of the focal points in medium and high-entropy alloys (MEAs-HEAs) since the first discovery of the HEA superconductor in 2014. Until now, most HEAs' superconducting transition temperature (Tc) has not exceeded…
We report a novel pressure-induced spin-density-wave transition in the superconductor Mo3Sb7 figured our by measurements of the electrical resistivity and magnetization under hydrostatic pressure. The critical temperature of superconducting…
We study the response of several microwave resonators made from superconducting NbTiN thin-film meandering nanowires with large kinetic inductance, having different circuit topology and coupling to the transmission line. Reflection…
Progress in superconducting device and detector technologies over the past decade have realized practical applications in quantum computers, detectors for far-infrared telescopes, and optical communications. Superconducting thin film…
We study mechanical dissipation of the fundamental mode of millimeter-sized, high quality-factor ($Q$) metalized silicon nitride membranes at temperatures down to 14 mK using a three-dimensional optomechanical cavity. Below 200 mK, high-$Q$…
We report experimental discovery of tantalum polyhydride superconductor. It was synthesized at high pressure and high temperature conditions using diamond anvil cell combined with in-situ high pressure laser heating techniques. The…
Silicon nitride (SiN) mechanical resonators with high quality mechanical properties are attractive for fundamental research and applications. However, it is challenging to maintain these mechanical properties while achieving strong coupling…
Here we present the microwave characterization of microstrip resonators made from aluminum and niobium inside a 3D microwave waveguide. In the low temperature, low power limit internal quality factors of up to one million were reached. We…
Thin films of TiN were sputter-deposited onto Si and sapphire wafers with and without SiN buffer layers. The films were fabricated into RF coplanar waveguide resonators, and internal quality factor measurements were taken at millikelvin…
If driven sufficiently strongly, superconducting microresonators exhibit nonlinear behavior including response bifurcation. This behavior can arise from a variety of physical mechanisms including heating effects, grain boundaries or weak…
We have designed, fabricated and tested a frequency-tunable high-Q superconducting resonator made from a niobium titanium nitride film. The frequency tunability is achieved by injecting a DC current through a current-directing circuit into…
Following optical pulses ($\lambda=405~\text{nm}$) on titanium nitride (TiN) Microwave Kinetic Inductance Detectors (MKIDs) cooled down at temperatures $T \le T_c / 20$ ($T_c \simeq 4.6~\text{K}$), we observe a large phase-response…
We introduce a microwave circuit architecture for quantum signal processing combining design principles borrowed from high-Q 3D resonators in the quantum regime and from planar structures fabricated with standard lithography. The resulting…
Polycrystalline sample of the new layered superconductor Bi4O4S3 is successfully synthesized by solid-state reaction method by using Bi, S and Bi2O3 powders with one step reaction. The superconducting transition temperature (Tconset=4.5 K),…
High-quality-factor ($Q$) mechanical resonators are essential components for precise sensing and control of mechanical motion at a quantum level. While amorphous materials such as SiN have been widely used in high-$Q$ mechanical resonators…
We present an experimental approach for cryogenic dielectric measurements on ultra-thin insulating films. Based on a coplanar microwave waveguide design we implement superconducting quarter-wave resonators with inductive coupling, which…
We established a production method of a good millimeter-wave absorber by using a 3D-printed mold. The mold has a periodic pyramid shape, and an absorptive material is filled into the mold. This shape reduces the surface reflection. The…
The pressure induced superconductivity and structural evolution for Bi2Se3 single crystal have been studied. The emergence of superconductivity with onset transition temperature (Tc) about 4.4K is observed around 12GPa. Tc increases rapidly…