Related papers: A MKID-readout based on a heterogeneous, closely c…
Current generation millimeter wavelength detectors suffer from scaling limits imposed by complex cryogenic readout electronics. To circumvent this it is imperative to investigate technologies that intrinsically incorporate strong…
We present MIDGARD, an open-source simulation platform for autonomous robot navigation in outdoor unstructured environments. MIDGARD is designed to enable the training of autonomous agents (e.g., unmanned ground vehicles) in photorealistic…
The separation and optimization of noise components is critical to microwave-kinetic inductance detector (MKID) development. We analyze the effect of several changes to the lumped-element inductor and interdigitated capacitor geometry on…
The highly sensitive millimeter-wave telescope is an important tool for accurate measurement of Cosmic Microwave Background (CMB) radiation, and its core component is a detector array located in a cryogenic focal plane. The feasibility of…
This paper describes a cryogenic optical testbed developed to characterize u-Spec spectrometers in a dedicated dilution refrigerator (DR) system. u-Spec is a far-infrared integrated spectrometer that is an analog to a Rowland-type grating…
Massive multiple-input multiple-out (MIMO) technology is vital in millimeter-wave (mmWave) bands to obtain large array gains. However, there are practical challenges, such as high hardware cost and power consumption in such systems. A…
CONCERTO is a millimeter-wave imaging instrument that operated on the Atacama Pathfinder Experiment (APEX) telescope from April 2021 to May 2023. Its primary scientific objectives include the study of galaxy clusters through the…
We demonstrate position and energy-resolved phonon-mediated detection of particle interactions in a silicon substrate instrumented with an array of microwave kinetic inductance detectors (MKIDs). The relative magnitude and delay of the…
The HASPIDE (Hydrogenated Amorphous Silicon PIxels DEtectors) project aims at the development of thin hydrogenated amorphous silicon (a-Si:H) detectors on flexible substrates (mostly Polyimide) for beam monitoring, neutron detection and…
We report on the design and performance of Microwave Kinetic Inductance Detectors (MKIDs) sensitive to single photons in the optical to near-infrared range using hafnium as the sensor material. Our test device had a superconducting…
We present the development status of the SOIKID, a detector combining the SOI pixel detector and the superconducting detector KID (Kinetic Inductance Detector). The aim of the SOIKID is to measure X-ray photon energy with the resolution…
Multiple-input multiple-output (MIMO) radar is one of the leading depth sensing modalities. However, the usage of multiple receive channels lead to relative high costs and prevent the penetration of MIMOs in many areas such as the…
A multiple input multiple output ultra-wideband cognitive radar based on compressive sensing is presented in this letter. For traditional UWB radar, high sampling rate analog to digital converter at the receiver is required to meet Shannon…
The foreseen Phase 2 pixel upgrades at the LHC have very challenging requirements for the design of hybrid pixel readout chips. A versatile pixel simulation platform is as an essential development tool for the design, verification and…
In view of a possible application as a charge-particle track readout for an Active-Target Time Projection Chamber (AT-TPC), the operational properties and performances of a hybrid Micro-Pattern Gaseous Detector (MPGD) were investigated in…
The Prime-Cam receiver on the Fred Young Submillimeter Telescope for the CCAT-prime project aims to address important astrophysical and cosmological questions with sensitive broadband, polarimetric, and spectroscopic measurements. The…
Heterogeneous devices such as the Multi-Processor System-on-Chip (MPSoC) from Xilinx are extremely valuable in custom instrumentation systems. This contribution presents the joint development of a heterogeneous MPSoC board called DTS-100G…
We present the design and measured performance of a light emitting diode (LED) module for spatially mapping kinetic inductance detector (KID) arrays in the laboratory. Our novel approach uses a multiplexing scheme that only requires seven…
There are many real-life use cases such as barcode scanning or billboard reading where people need to detect objects and read the object contents. Commonly existing methods are first trying to localize object regions, then determine layout…
Kinetic Inductance Detectors (KIDs) are superconductive low$-$temperature detectors useful for astrophysics and particle physics. We have developed arrays of lumped elements KIDs (LEKIDs) sensitive to microwave photons, optimized for the…