Related papers: Grease the gears for a steady microfluidic flow
We combine non-hydrostatic flow simulations of the free surface with a discharge model based on elementary gate flow equations for decision support in operation of hydraulic structure gates. A water level-based gate control used in most of…
This paper provides a prescription for the turbulent viscosity in rotating shear flows for use e.g. in geophysical and astrophysical contexts. This prescription is the result of the detailed analysis of the experimental data obtained in…
Powders are a special class of granular matter due to the important role of cohesive forces. The flow behavior of powders depends on the flow states and stress and is therefore difficult to measure/quantify with only one experiment. In this…
Controlling bacterial surface adhesion and subsequent biofilm formation in fluid systems is crucial for the safety and efficacy of medical and industrial processes. Here, we theoretically examine the transport of bacteria close to surfaces,…
The precise description of the motion of anisotropic particles in a flow rests on the understanding of the force and torque acting on them. Here, we study experimentally small, very elongated particles settling in a fluid at small Reynolds…
Turbulence is the major cause of friction losses in transport processes and it is responsible for a drastic drag increase in flows over bounding surfaces. While much effort is invested into developing ways to control and reduce turbulence…
Pumped storage type hydropower plants play an important role in mitigating real-time energy flexibility. Reversible pump-turbines undergo extreme operating conditions such as runaway and speed-no-load. Very limited studies are undertaken to…
The main objective of this paper is finding effective gearbox condition monitoring methods by using continuously recorded monitoring SCADA (Supervisory Control and Data Accusation) data points. Typically for wind turbine gearbox condition…
Results are reported of an experimental investigation into the motion of a heavy cylinder free to move inside a water-filled drum rotating around a horizontal axis. The cylinder is observed to either co- or, counter intuitively,…
The emergence of a submerged vortex upstream of a pump can reduce pump intake efficiency and cause structural damage. In this study, we consider the use of active flow control with steady blowing to increase the pressure distribution within…
Direct numerical simulations of spanwise-rotating turbulent channel flow with a parabolic bump on the bottom wall are employed to investigate the effects of rotation on flow separation. Four rotation rates of $Ro_b := 2\Omega H/U_b = \pm…
Ongoing development of fuel storage and delivery systems for space probes, interplanetary vehicles, satellites and orbital platforms continues to drive interest in propellant management systems that utilize surface tension to retain,…
In most settings, from international pipelines to home water supplies, the drag caused by turbulence raises pumping costs many times higher than if the flow were laminar. Drag reduction has therefore long been an aim of high priority. In…
Despite extensive studies on either smooth granular-fluid flow or the solid-like deformation at the slow limit, the change between these two extremes remains largely unexplored. By systematically investigating the fluctuations of tightly…
Experimental investigations of the exit dynamics of a horizontal cylindrical object were performed in water and silicone oil (50 cSt). The fully immersed cylinder was initially at rest in a still fluid tank before being pushed (or pulled…
Vertical sloshing in partially filled fuel tanks can significantly impact vehicle stability and structural integrity, particularly under harmonic accelerations near twice the sloshing natural frequency. In this regime, parametric resonance…
Using essentially our 2011 numerical model of a multi-lymphangion segment of a collecting lymphatic vessel, but augmented by inclusion of a refractory period and definition of a mid lymphangion pressure, we explore the effect of several…
We study the transient start-up dynamics of a fluidity model which captures the rheological behavior of aging soft glassy materials, in a rectilinear shear flow upon application of step shear rate. We observe that when the steady state flow…
The flow profile in a capillary gap and the pumping efficiency of an acoustic micropump employing Surface Acoustic Waves is investigated both experimentally and theoretically. Such ultrasonic surface waves on a piezoelectric substrate…
Microfluidic systems are usually fabricated with soft materials that deform due to the fluid stresses. Recent experimental and theoretical studies on the steady flow in shallow deformable microchannels have shown that the flow rate is a…