Related papers: Performances of an upgraded front-end-board for th…

In the readout electronics of the Water Cerenkov Detector Array (WCDA) in the Large High Altitude Air Shower Observatory (LHAASO) experiment, both high-resolution charge and time measurement are required over a dynamic range from 1…

Prime-Cam is a first-generation science instrument for the CCAT Observatory's six-meter aperture Fred Young Submillimeter Telescope (FYST). FYST's crossed-Dragone design provides high optical throughput to take advantage of its unique site…

In October 2019 the central 28m telescope of the H.E.S.S. experiment has been upgraded with a new camera. The camera is based on the FlashCam design which has been developed in view of a possible future implementation in the medium-sized…

A system for bunch-by-bunch detection of transverse proton and antiproton coherent oscillations in the Fermilab Tevatron collider is described. It is based on the signal from a single beam-position monitor located in a region of the ring…

'EPECUR' experiment setup is under construction at the beam line 322 of the ITEP proton synchrotron. The experiment requires several large area drift chambers to provide reasonable acceptance and fine pitch proportional chambers for beam…

The Beijing Spectrometer III (BESIII) endcap Time-Of-Filght (ETOF) was proposed to upgrade with Multigap Resistive Plate Chamber (MRPC) technology to substitute the current ETOF of scintillator+PMT for extending time resolutin better than…

The Cherenkov Telescope Array (CTA) represents the next generation of ground based instruments for Very High Energy gamma-ray astronomy. It is expected to improve on the sensitivity of current instruments by an order of magnitude and…

The FERS-5200 is the new CAEN Front-End Readout System for large detector arrays. It consists in a compact, distributed and easy-deployable solution integrating front-end based on ASICs, A/D conversion, data processing, synchronization and…

FEbeam is a compact field emission data processing interface with the capability to analyze the field emission cathode performance in an rf injector by extracting the field enhancement factor, local field, and effective emission area from…

Electron microscopy is a powerful tool for visualizing the shapes of sub-nanometer objects. However, contrast is not in proportional to density distribution, and therefore achieving a quantitative understanding of specimens is not…

A completely New Small Wheel (NSW) will be constructed for ATLAS Phase-1 upgrade. Small-Strip Thin-Gap-Chamber (sTGC) will devote to the trigger function of NSW. A full-size sTGC quadruplet consists of 4 layers, and will need 4 pad…

The Cherenkov Telescope Array (CTA) is a future ground-based observatory for gamma-ray astronomy providing unparalleled sensitivity in the energy range from 20 GeV up to 300 TeV. CTA will consist of telescopes with three different sizes.…

Noise efficiency factor (NEF) and power efficiency factor (PEF) are widely used as the figure of merit to quantify the performance of biopotential recording front-ends. NEF and PEF are discussed from the noise analysis to the trend survey.…

In this paper, we compare different metrics to predict the error rate of optical systems based on nonbinary forward error correction (FEC). It is shown that the correct metric to predict the performance of coded modulation based on…

i-TED is an innovative detection system which exploits Compton imaging techniques to achieve a superior signal-to-background ratio in ($n,\gamma$) cross-section measurements using time-of-flight technique. This work presents the first…

The prototype camera of the single-mirror Small Size Telescopes (SST-1M) proposed for the Cherenkov Telescope Array (CTA) project has been designed to be very compact and to deliver high performance over thirty years of operation. The…

The prototype of time digitizing system for the upgrade of BESIII endcap TOF (ETOF) is introduced in this paper. The ETOF readout electronics has a formation of distributed architecture that hit signal from multi-gap resistive plate chamber…

Currently the standard light sensors for imaging atmospheric Cherenkov telescopes are the classical photo multiplier tubes that are using bialkali photo cathodes. About eight years ago we initiated an improvement program with the Photo…

The Fast Tracker (FTK) is an ATLAS trigger upgrade built for full event, low-latency, high-rate tracking. The FTK core, made of 9U VME boards, performs the most demanding computational task. The Associative Memory Board Serial Link…

Maintaining the required performance of the CMS electromagnetic calorimeter (ECAL) barrel at the High-Luminosity Large Hadron Collider (HL-LHC) requires the replacement of the entire on-detector electronics. 12240 new very front end (VFE)…