Related papers: Forced oscillation source localization from genera…
We study the dynamics of a one-dimensional lattice model of hard core bosons which is initially in a superfluid phase with a current being induced by applying a twist at the boundary. Subsequently, the twist is removed and the system is…
Here we develop an approach to predict power grid weak points, and specifically to efficiently identify the most probable failure modes in static load distribution for a given power network. This approach is applied to two examples: Guam's…
This paper introduces an algorithm able to detect and localize the occurrance of a fault in an Active Distribution Network, using the measurements collected by Phasor Measurement Units (PMUs). First, a basic algorithm that works under the…
The increasing penetration of renewable energy sources has been leading to the progressive phase-out of synchronous generators, which constitute the main source of frequency stability for electric power systems. In the light of these…
Location of non-stationary forced oscillation (FO) sources can be a challenging task, especially in cases under resonance condition with natural system modes, where the magnitudes of the oscillations could be greater in places far from the…
The increasing adoption of renewable energy sources has significantly reduced the inertia in the modernized power grid, making the system more vulnerable. One way to stabilize the grid is to add extra inertia from unused turbines, called…
Introduction of renewable generation leads to significant reduction of inertia in power system, which deteriorates the quality of frequency control. This paper suggests a new control scheme utilizing controllable load to deal with low…
Most studies that consider the problem of estimating the location of a point source in wireless sensor networks assume that the source location is estimated by a set of spatially distributed sensors, whose locations are fixed. Motivated by…
Autonomous robot networks are an effective tool for monitoring large-scale environmental fields. This paper proposes distributed control strategies for localizing the source of a noisy signal, which could represent a physical quantity of…
The electrical grid is evolving from a network consisting of mostly synchronous machines to a mixture of synchronous machines and inverter-based resources such as wind, solar, and energy storage. This transformation has led to a decrease in…
We present a systematic method to design ubiquitous continuous fast-acting distributed load control for primary frequency regulation in power networks, by formulating an optimal load control (OLC) problem where the objective is to minimize…
Wide Area Measurement Systems (WAMS) can guide system operators' to increase their situational awareness by expanding observability of their supervise area and adjoining systems. Power system oscillations in the electrical grid are a matter…
The oscillation phenomena associated with the control of voltage source converters (VSCs) are widely concerning, and locating the source of these oscillations is crucial to suppressing them; therefore, this paper presents a locating scheme,…
An important task in structural design is to quantify the structural performance of an object under the external forces it may experience during its use. The problem proves to be computationally very challenging as the external forces'…
Cascading failure of a power transmission system are initiated by an exogenous event that disable a set of elements (e.g., lines) followed by a sequence of interrelated failures (or more precisely, trips) of overloaded elements caused by…
Traveling wave theory is deployed today to improve the monitoring of transmission lines in electrical power grids. Most traveling wave methods require prior knowledge of the wave propagation of the transmission line, which is a major source…
Source localization in a complex flow poses a significant challenge for multi-robot teams tasked with localizing the source of chemical leaks or tracking the dispersion of an oil spill. The flow dynamics can be time-varying and chaotic,…
In this paper, the simulation of the disturbance propagation through a large power system is performed on the WSCC 127 bus test system. The signal frequency analysis from several parts of the power system is performed by applying the…
We study the stationary and nonstationary measurement of a classical force driving a mechanical oscillator coupled to an electromagnetic cavity under two-tone driving. For this purpose, we develop a theoretical framework based on the…
Received signal strength (RSS)-based wireless localization is easy to implement at low cost. In practice,exact positions of anchors may not be available. This paper focuses on determining the location of a source in the presence of…