Related papers: Uplink Power Control for Distributed Massive MIMO …
This paper provides the signal-to-interference-plus-noise ratio (SINR) complimentary cumulative distribution function (CCDF) and average data rate of the normalized SNR-based scheduling in an uplink cellular network using stochastic…
We propose a downlink beamforming scheme that combines spatial division and orthogonal space-time block coding (OSTBC) in multi-user massive MIMO systems. The beamformer is divided into two parts: a pre-beamforming matrix to separate the…
Massive multiple-input multiple-output (MIMO) networks, where the base stations (BSs) are equipped with large number of antennas and serve a number of users simultaneously, are very promising, but suffer from pilot contamination. Despite…
One of key 5G scenarios is that device-to-device (D2D) and massive multiple-input multiple-output (MIMO) will be co-existed. However, interference in the uplink D2D underlaid massive MIMO cellular networks needs to be coordinated, due to…
This paper aims to minimize the total transmit power consumption for Massive MIMO (multiple-input multiple-output) downlink cellular systems when each user is served by the optimized subset of the base stations (BSs). We derive a lower…
This paper considers the jointly optimal pilot and data power allocation in single cell uplink massive MIMO systems. A closed form solution for the optimal length of the training interval is derived. Using the spectral efficiency (SE) as…
Power control is a fundamental task accomplished in any wireless cellular network; its aim is to set the transmit power of any mobile terminal, so that each user is able to achieve its own target SINR. While conventional power control…
In this letter, we investigate the uplink of a reconfigurable intelligent surface (RIS)-aided millimeter-wave (mmWave) multi-user system. In the considered system, however, problems with hardware cost and power consumption arise when…
This paper investigates the spectral efficiency achieved through uplink joint transmission, where a serving user and the network users (UEs) collaborate by jointly transmitting to the base station (BS). The analysis incorporates the…
We study the impact of hardware impairments at the base station (BS) of an orthogonal frequency-division multiplexing (OFDM)-based massive multiuser (MU) multiple-input multiple-output (MIMO) uplink system. We leverage Bussgang's theorem to…
Energy efficiency is a growing concern for wireless networks, not only due to the emerging traffic demand from smart devices, but also because of the dependence on the traditional unsustainable energy and the overall environmental concerns.…
This paper considers an uplink cellular system, in which each base station (BS) is equipped with a large number of antennas to serve multiple single-antenna user equipments (UEs) simultaneously. Uplink training with pilot reusing is adopted…
In this paper, the problem of uplink (UL) and downlink (DL) resource optimization, mode selection and power allocation is studied for wireless cellular networks under the assumption of in-band full duplex (IBFD) base stations,…
In this paper, two modulation schemes based on complementary sequences (CSs) are proposed for uplink control channels in unlicensed bands. These schemes address high peak-to-average-power ratio (PAPR) under non-contiguous resource…
Cell-free massive MIMO (CF-mMIMO) provides wireless connectivity for a large number of user equipments (UEs) using access points (APs) distributed across a wide area with high spectral efficiency (SE). The energy efficiency (EE) of the…
Power control is becoming increasingly essential for the fifth-generation (5G) and beyond systems. An example use-case, among others, is the unmanned-aerial-vehicle (UAV) communications where the nearly line-of-sight (LoS) radio channels…
A multicell-coordinated beamforming solution for massive multiple-input multiple-output orthogonal frequency-division multiplexing (OFDM) systems is presented when employing low-resolution data converters and per-antenna level constraints.…
The low-resolution analog-to-digital convertor (ADC) is a promising solution to significantly reduce the power consumption of radio frequency circuits in massive multiple-input multiple-output (MIMO) systems. In this letter, we investigate…
In millimeter wave (mmWave) systems, we investigate uplink user scheduling when a basestation employs low-resolution analog-to-digital converters (ADCs) with a large number of antennas. To reduce power consumption in the receiver,…
Smart and reconfigurable wireless communication environments can be established by exploiting well-designed intelligent reflecting surfaces (IRSs) to shape the communication channels. In this paper, we investigate how multiple IRSs affect…