Related papers: A Simple Modification of DC Current Septa to Reduc…
We reveal obstacles related to the application of HTS cylinders in current limiting devices based on the superconducting - normal state transition. It is shown that, at the critical current density achieved presently in bulk materials, and…
A racetrack coil using MgB2/Cu strand has been fabricated and tested for transport current density at 4.2 K in self field. The monofilamentary strand was 1.0 mm OD and insulated with S-glass braid. Eighty turns of strand (42 m) were wound…
Focused electron beam induced deposition of pure materials from aqueous solutions has been of interest in recent years. However, controlling the liquid film in partial vacuum is challenging. Here we modify the substrate to increase control…
A drastic cumulation of current density caused by electrostatic repulsion in relativistic vacuum diodes with ring-type cathodes is described theoretically and confirmed experimentally. The distinctive feature of the suggested cumulation…
The Self-Excited Loop (SEL) architecture, used in some continuous-wave (CW) superconducting linacs, relies on a positive feedback mechanism that requires carefully defined operating limits to ensure stable operation. These limits are…
A description of an edge-biasing experiment conducted on the SPECTOR (Spherical Compact Toroid) plasma injector is presented, along with initial results. The insertion of a disc-shaped molybdenum electrode (probe), biased at up to +100V,…
The Rapid Cycling Synchrotron (RCS) in Chinese Spallation Neutron Source (CSNS) accelerates proton beam from 80Mev to 1.6GeV at a repetition rate of 25Hz. All dipole magnets of RCS are operated at AC with biased DC. Aiming at the properties…
We study theoretically the ac Josephson effect in superconducting planar d-wave junctions. The insulating barrier assumed to be present between the two superconductors may have arbitrary strength. Many properties of this system depend on…
The combined action of a DC bias and a microwave drive on the transport characteristic of a superconductor-quantum dot-superconductor junction is investigated. To cope with time dependent non-equilibrium effects and interactions in the…
Increasing the Fermilab Main Injector (MI) beam power above ~1.2 MW requires replacement of the 8 GeV Booster by a higher intensity alternative. Earlier, rapid-cycling synchrotron and linac solutions were considered for this purpose. In…
The InAs/InGaAs DWELL solar cell grown by MBE is a standard pin diode structure with six layers of InAs QDs embedded in InGaAs quantum wells placed within a 200-nm intrinsic GaAs region. The GaAs control wafer consists of the same pin…
In this study, a low energy beam transport (LEBT) channel for the proton linac section of the Turkic Accelerator Complex (TAC) has been designed by using TRACE 2D and TRAVEL codes. The LEBT channel is located between an ion source and a…
To facilitate high optical coupling efficiency and absorptance, the active area of a superconducting nano/microstrip single-photon detector (SNSPD/SMSPD) is often designed as a meander configuration with a high filling factor (e.g., >=0.5).…
Using a focused He$^+$ beam for nanopatterning and writing of Josephson barriers we fabricated specially shaped Josephson junctions of in-line geometry in YBa$_2$Cu$_3$O$_7$ thin film microbridges with an asymmetry ratio of critical…
MESA (Mainz Energy recovery Superconducting Accelerator) is an energy recovery linac (ERL) which is under construction at Johannes Gutenberg University in Mainz. It will be operated in external beam (EB) mode with 150 $\mu$A electron beam…
This paper reports a newly developed high current transformer-rectifier High-Tc Superconducting (HTS) flux pump switched by dynamic resistance. A quasi-persistent current of over 1.1 kA has been achieved at 77 K using the device, which is…
The Continuous Electron Beam Accelerator Facility (CEBAF) and associated experimental equipment at Jefferson Lab comprise a unique facility for experimental nuclear physics. This facility is presently being upgraded, which will enable a new…
Current leads are utilized to deliver electrical power from a room temperature junction mounted on the vacuum vessel to a superconducting magnet located within the vacuum space of a cryostat. There are many types of current leads used at…
We report a systematic study on the electronic structure and superconducting (SC) gaps in electron doped NaFe$_{0.95}$Co$_{0.05}$As superconductor using angle-resolved photoemission spectroscopy. Hole-like Fermi sheets are at the zone…
This paper presents non-destructive dark current measurements of superconducting TESLA cavities for superconducting LINACs. The measurements were carried out in a highly disturbed accelerator environment using a low temperature…