Related papers: Achievable Rate Region and Path-Based Beamforming …
We investigate the capacity attainable for a multiuser MIMO uplink as we scale both array size and bandwidth for regimes in which all-digital arrays incur excessive hardware complexity and power consumption. We consider a tiled hybrid…
In this paper, an efficient beam and channel acquisition scheme together with joint angle-delay power profile (JADPP) construction are proposed for single-carrier mm-wave wideband sparse massive multiple-input multiple-output (MIMO)…
Millimeter wave (mmWave) communication with large array gains is a key ingredient of next generation (5G) wireless networks. Effective communication in mmWaves usually depends on the knowledge of the channel. We refer to the problem of…
We model the self-interference in a multiple input single output (MISO) full-duplex two-way channel and evaluate the achievable rate region. We formulate the boundary of the achievable rate region termed as the Pareto boundary by a family…
The recent concept of beamspace multiple input multiple output (MIMO) can significantly reduce the number of required radio-frequency (RF) chains in millimeter-wave (mmWave) massive MIMO systems without obvious performance loss. However,…
MIMO systems in the lower part of the millimeter-wave spectrum band (i.e., below 28 GHz) do not exhibit enough directivity and selectively, as their counterparts in higher bands of the spectrum (i.e., above 60 GHz), and thus still suffer…
Integrated Sensing and Communication (ISAC) has attracted substantial attraction in recent years for spectral efficiency improvement, enabling hardware and spectrum sharing for simultaneous sensing and signaling operations. In-band Full…
This paper addresses the challenge of coordinating multi-robot systems under realistic communication delays using distributed optimization. We focus on consensus ADMM as a scalable framework for generating collision-free, dynamically…
Integrated sensing and communication (ISAC) is emerging as a pivotal technology for next-generation wireless networks. However, existing ISAC systems are based on fixed-position antennas (FPAs), which inevitably incur a loss in performance…
We propose a downlink beamforming scheme that combines spatial division and orthogonal space-time block coding (OSTBC) in multi-user massive MIMO systems. The beamformer is divided into two parts: a pre-beamforming matrix to separate the…
Dual-functional radar-communication (DFRC) has attracted considerable attention. This paper considers the frequency-selective multipath fading environment and proposes DFRC waveform design schemes based on multiple-input and multiple-output…
Hybrid analog and digital beamforming has emerged as a key enabling technology for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communication systems since it can balance the trade-off between system performance…
This paper proposes an adaptive multi-mode transmission strategy to improve the spectral efficiency achieved in the multiple-input multiple-output (MIMO) broadcast channel with delayed and quantized channel state information. The adaptive…
The large spectrum available in the millimeter-Wave (mmWave) band has emerged as a promising solution for meeting the huge capacity requirements of the 5th generation (5G) wireless networks. However, to fully harness the potential of mmWave…
Large-scale multiple-input and multiple-output (MIMO) systems are capable of achieving high date rate. However, given the high hardware cost and excessive power consumption of massive MIMO systems, as a remedy, intelligent metasurfaces have…
In this paper, we address the problem of transmit beamspace design for multiple-input multiple-output (MIMO) radar with colocated antennas in application to direction-of-arrival (DOA) estimation. A new method for designing the transmit…
We consider a two-way relay network, where two source nodes, S1 and S2, exchange information through a cluster of relay nodes. The relay nodes receive the sum signal from S1 and S2 in the first time slot. In the second time slot, each relay…
Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…
High power consumption and expensive hardware are two bottlenecks for practical massive multiple-input multiple-output (mMIMO) systems. One promising solution is to employ low-resolution analog-to-digital converters (ADCs) and…
Millimeter wave (mmWave) band, or high frequencies such as THz, has large undeveloped band of spectrum. However, wireless channels over the mmWave band usually have one or two paths only due to the severe attenuation. The channel property…