Related papers: Channel Estimation Using RIDNet Assisted OMP for H…

Channel estimation is challenging for millimeter-wave (mmWave) massive MIMO with hybrid precoding, since the number of radio frequency (RF) chains is much smaller than that of antennas. Conventional compressive sensing based channel…

In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…

Accurate channel estimation is essential for reliable communication in sub-THz extremely large (XL) MIMO systems. Deploying XL-MIMO in high-frequency bands not only increases the number of antennas, but also fundamentally alters channel…

This letter investigates the channel estimation problem in THz wireless communications where a RIS is employed to assist wireless transmission between different devices. Unlike existing studies, we consider a novel scenario where specific…

Reconfigurable intelligent surface (RIS) has been recognized as a promising technology for next-generation wireless communications. However, the performance of RIS-assisted systems critically depends on accurate channel state information…

Channel estimation for hybrid Multiple Input Multiple Output (MIMO) systems at Millimeter-Waves (mmW)/sub-THz is a fundamental, despite challenging, prerequisite for an efficient design of hybrid MIMO precoding/combining. Most works propose…

This paper addresses the problem of estimating sparse channels in massive MIMO-OFDM systems. Most wireless channels are sparse in nature with large delay spread. In addition, these channels as observed by multiple antennas in a neighborhood…

Massive MIMO is one of the main features of 5G mobile radio systems. However, it often leads to high cost, size and power consumption. To overcome these issues, the use of constrained radio frequency (RF) frontends has been proposed, as…

In this work, we study a six-dimensional movable antenna (6DMA)-enhanced Terahertz (THz) network that supports a large number of users with a few antennas by controlling the three-dimensional (3D) positions and 3D rotations of antenna…

Hybrid precoding is a key ingredient of cost-effective massive multiple-input multiple-output transceivers. However, setting jointly digital and analog precoders to optimally serve multiple users is a difficult optimization problem.…

In millimeter-wave (mmWave) MIMO systems, while a hybrid digital/analog precoding structure offers the potential to increase the achievable rate, it also faces the challenge of the need of a low-complexity design. In specific, the hybrid…

Extremely large-scale multiple-input-multiple-output (XL-MIMO) with hybrid precoding is a promising technique to meet the high data rate requirements for future 6G communications. To realize efficient hybrid precoding, it is essential to…

Terahertz (THz) communications is considered as one of key solutions to support extremely high data demand in 6G. One main difficulty of the THz communication is the severe signal attenuation caused by the foliage loss, oxygen/atmospheric…

Terahertz (THz) systems have the benefit of high bandwidth and hence are capable of supporting ultra-high data rates, albeit at the cost of high pathloss. Hence they tend to harness high-gain beamforming. Therefore a novel hybrid 3D…

Accurate and efficient estimation of the high dimensional channels is one of the critical challenges for practical applications of massive multiple-input multiple-output (MIMO). In the context of hybrid analog-digital (HAD) transceivers,…

Extremely large-scale massive MIMO (XL-MIMO) is a promising technique for future 6G communications.However, existing far-field or near-field channel model mismatches the hybrid-field channel feature in the practical XL-MIMO…

In recent years, orthogonal chirp-division multiplexing (OCDM) has been increasingly considered as an alternative multicarrier scheme, e.g., to orthogonal frequency-division multiplexing, in digital communication applications. Among reasons…

This paper studies wideband channel estimation for OFDM systems assisted by extremely large RIS (XL-RIS). Due to the large aperture of XL-RISs, the user equipment may operate in the near-field region, while the base station-XL-RIS link…

The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…

Reconfigurable intelligent surface (RIS) is very promising for wireless networks to achieve high energy efficiency, extended coverage, improved capacity, massive connectivity, etc. To unleash the full potentials of RIS-aided communications,…