Related papers: Enhanced temperature sensing by multi-mode couplin…
Nanocavities formed by ultrathin metallic gaps, such as the nanoparticle-on-mirror geometry, permit the reproducible engineering and enhancement of light-matter interaction thanks to mode volumes reaching the smallest values allowed by…
Temperature imaging of nanoscale systems is a fundamental problem which has myriad potential technological applications. For example, nanoscopic cold spots can be used for spot cooling electronic components while hot spots could be used for…
This paper proposes a novel multifunctional sensing platform based on multimode planar photonic crystals (PPCs). We analytically and numerically demonstrate that the reflection spectrum of PPCs exhibits multiple high-Q resonant modes, and…
We present an integrated optomechanical and electromechanical nanocavity, in which a common mechanical degree of freedom is coupled to an ultrahigh-Q photonic crystal defect cavity and an electrical circuit. The sys- tem allows for…
We demonstrate a multipurpose microwave frequency identification solution that is implemented based on a photonic integrated chip and is able to identify different types of microwave signals, including single-frequency, multiple-frequency,…
A transient and high sensitivity sensor based on high-Q microcavity is proposed and studied theoretically. There are two ways to realize the transient sensor: monitor the spectrum by fast scanning of probe laser frequency or monitor the…
We propose and demonstrate a self-coupled microring resonator for resonance splitting by mutual mode coupling of cavity mode and counter-propagating mode in Silicon-on-Insulator platform The resonator is constructed with a self-coupling…
Quantifying the temperature of microdevices is critical for probing nanoscale energy transport.Such quantification is often accomplished by integrating resistance thermometers into microdevices. However, such thermometers frequently become…
In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…
Recent progresses have revealed that quantum systems with multiple position-dependent couplings, e.g., giant atoms, can exhibit some unconventional phenomena, such as non-exponential decay etc. However, their potential applications are…
Suspended optical microresonators are promising devices for on-chip photonic applications such as radio-frequency oscillators, optical frequency combs, and sensors. Scaling up these devices demand the capability to tune the optical…
Optical frequency stabilization is a critical component for precision scientific systems including quantum sensing, precision metrology, and atomic timekeeping. Ultra-high quality factor photonic integrated optical resonators are a prime…
Nano-electro-opto-mechanical systems enable the synergistic coexistence of electrical, mechanical, and optical signals on a chip to realize new functions. Most of the technology platforms proposed for the fabrication of these systems so far…
Cavities in large-scale photonic integrated circuits often suffer from a wider distribution of resonance frequencies due to fabrication errors. It is crucial to adjust the resonances of cavities using post-processing methods to minimize the…
We outline a full-vectorial three-dimensional multi-mode matching technique in a cylindrical coordinate system that addresses the mutual coupling among multiple modes copropagating in a perturbed whispering-gallery-mode microcavity. In…
High frequency mechanical resonators subjected to low thermal phonon occupancy are easier to be prepared to the ground state by direct cryogenic cooling. Their extreme stiffness, however, poses a significant challenge for external…
Accurate on-chip temperature sensing is critical for the optimal performance of modern CMOS integrated circuits (ICs), to understand and monitor localized heating around the chip during operation. The development of quantum computers has…
Optical mode-splitting is an efficient tool to shape and fine-tune the spectral response of resonant nanophotonic devices. The active control of mode-splitting, however, is either small or accompanied by undesired resonance shifts, often…
We demonstrate an on-chip device utilizing the concept of artificial cavity magnon-polariton (CMP) coupling between the microwave cavity mode and the dynamics of the artificial magnetism in a split ring resonator. This on-chip device allows…
Cavity electro-(opto-)mechanics allows us to access not only single isolated but also multiple mechanical modes in a massive object. Here we develop a multi-mode electromechanical system in which a several membrane vibrational modes are…