Related papers: Real-time frequency measurement based on parallel …
The precise analysis and accurate measurement of harmonic provides a reliable scientific industrial application. However, the high-performance DSP processor is the important method of electrical harmonic analysis. Hence, in this research…
This research work focuses on the design of a high-resolution fast Fourier transform (FFT) /inverse fast Fourier transform (IFFT) processors for constraints analysis purpose. Amongst the major setbacks associated with such high resolution,…
In this paper, the filter- and frequency-to-time mapping (FTTM)-based photonics-assisted time and frequency acquisition methods are comprehensively analyzed and the accuracy and resolution limitation in the fast sweep scenario is broken by…
In this paper phase of a signal has been viewed from a different angle. According to this view a signal can have countably infinitely many phases, one associated with each Fourier component. In other words each frequency has a phase…
Frequency Phase Transfer (FPT) is a technique designed to increase coherence and sensitivity in radio interferometry by making use of the non-dispersive nature of the troposphere to calibrate high-frequency data using solutions derived at a…
The presence of interharmonics in power systems can lead to asynchronous sampling, a phenomenon further aggravated by shifts in the fundamental frequency, which significantly degrades the accuracy of power measurements. Under such…
The graph Fourier transform (GFT) is a fundamental tool in graph signal processing and has recently been extended to the graph fractional Fourier transform (GFRFT). Existing sampling methods in the GFRFT domain are primarily designed to…
This paper investigates the effects of setting the sampling frequency significantly higher than conventional guidelines in system identification. Although continuous-time identification methods resolve the numerical difficulties encountered…
This paper introduces an innovative approach for signal reconstruction using data acquired through multi-input-multi-output (MIMO) sampling. First, we show that it is possible to perfectly reconstruct a set of periodic band-limited signals…
Choosing an appropriate frequency definition and norm is critical in graph signal sampling and reconstruction. Most previous works define frequencies based on the spectral properties of the graph and use the same frequency definition and…
The recovery of bandlimited signals with high dynamic range is a hot issue in sampling research. The unlimited sampling theory expands the recordable range of traditional analog-to-digital converters (ADCs) arbitrarily, and the signal is…
The fine timing measurement (FTM) protocol is designed to determine precise ranging between Wi-Fi devices using round-trip time (RTT) measurements. However, the multipath propagation of radio waves generates inaccurate timing information,…
A wavelet transform spectrum analyzer operating in real time within the frequency range 3X10^(-5) - 1.3X10^5 Hz has been implemented on a low-cost Digital Signal Processing board operating at 150MHz. The wavelet decomposition of the signal…
The upper mid-band (or FR3, spanning 6-24 GHz) is a crucial frequency range for next-generation mobile networks, offering a favorable balance between coverage and spectrum efficiency. From another perspective, the systems operating in the…
We demonstrate experimentally an optical system for under-sampling several bandwidth limited signals with carrier frequencies that are not known apriori that can be located anywhere within a very broad frequency region between 0-18 GHz. The…
With the growing demand for non-Euclidean data analysis, graph signal processing (GSP) has gained significant attention for its capability to handle complex time-varying data. This paper introduces a novel sampling method based on the joint…
In most work to date, graph signal sampling and reconstruction algorithms are intrinsically tied to graph properties, assuming bandlimitedness and optimal sampling set choices. However, practical scenarios often defy these assumptions,…
An accurate treatment of electronic spectra in large systems with a technique such as time dependent density functional theory (TDDFT) is computationally challenging. Due to the Nyquist sampling theorem, direct real time simulations must be…
The First Passage Time (FPT) is the time taken for a stochastic process to reach a desired threshold. In this letter we address the FPT of the stochastic measurement current in the case of continuously measured quantum systems. Our approach…
This technical note is on digital filters for the high-fidelity estimation of a sinusoidal signal's frequency in the presence of additive noise. The complex noise is assumed to be white (i.e. uncorrelated) however it need not be Gaussian.…