Related papers: On Paradoxical Phenomena During Evaporation and Co…
In a recent Letter [A. Lapolla and A. Godec, Phys. Rev. Lett. 125, 110602 (2020)], thermal relaxation was observed to occur faster from cold to hot (heating) than from hot to cold (cooling). Here we show that overdamped diffusion in…
This investigation deals with the analysis of stagnation point heat transfer and corresponding flow features of hydromagnetic viscous incompressible fluid over a vertical shrinking sheet. The considered sheet is assumed to be permeable and…
In this paper, we focus on the study of heat transfer behavior for the dual-phase-lag heat conduction model, which describes the evolution of temperature in a two-dimensional rectangular plate caused by the activity of a point heat source…
We study the rotational and vibrational heating of diatomic molecules placed near a surface at finite temperature on the basis of macroscopic quantum electrodynamics. The internal molecular evolution is governed by transition rates that…
It is well known that in a gas-filled duct or channel along which a temperature gradient is applied, a thermal creep flow is created. Here we show that a mass and momentum flux can also be induced in a gas confined between two parallel…
We investigate the evolution of interfaces among phases of the interstellar medium with different temperature. It is found that, for some initial conditions, the dynamical effects related to conductive fronts are very important even if…
In stars and planets natural processes heat convective flows in the bulk of a convective region rather than at hard boundaries. By characterizing how convective dynamics are determined by the strength of an internal heating source we can…
The injection of liquid fuel at supercritical pressures is a relevant topic in combustion, but usually overlooked. In the past, the wrong assumption whereby the liquid experiments a fast transition to a supercritical state was made, thus…
The two-phase mixing layer formed between parallel gas and liquid streams is an important fundamental problem in turbulent multiphase flows. The problem is relevant to many industrial applications and natural phenomena, such as air-blast…
The control of the thermocapillary assembly of colloidal particle clusters is important for a variety of applications, including the creation of photonic crystals for microelectronics and optoelectronics, membrane formation for…
During liquid evaporation, the temperature of the liquid determines the saturated vapor pressure above it, which controls the evaporation rate and thus determines the liquid temperature through latent heat. Therefore, the equations for the…
In this paper thermal conductivity and thermal diffusivity of a two layer system is examined from the theoretical point of view. We use the one dimensional heat diffusion equation with the appropriate solution in each layer and boundary…
Accurate evaluation of enthalpy of vaporization (or latent heat of vaporization) and its variation with temperature is of great interest in practical applications, especially for combustion of liquid fuels. Currently, a theoretically…
In the fabrication of optical fibres, the viscosity of the glass varies dramatically with temperature so that heat transfer plays an important role in the deformation of the fibre geometry. Surprisingly, for quasi-steady drawing, with…
The bi-layered structure has drawn a wide interest due to its good performance in solar steam generation. In this work, we firstly develop a calculation model which could give a good prediction of experimental results. Then, this model is…
Thanks to an expansion with respect to densities of energy, mass and entropy, we discuss the concept of thermocapillary fluid for inhomogeneous fluids. The non-convex state law valid for homogeneous fluids is modified by adding terms taking…
A theoretical model is developed for the forced convection film boiling phenomenon over a heated sphere moving vertically downwards in the water. Unprecedented to the previous analytical studies, this model accounts for the buoyancy effects…
A comprehensive review of current analytical models, experimental techniques, and influencing factors is carried out to highlight the current challenges in this area. The study of fluid-solid boundary conditions has been ongoing for more…
Transition boiling is an intermediate regime occurring between nucleate boiling, where bubbles at the surface efficiently carry heat away, and film boiling, where a layer of vapor formed over the surface insulates the system reducing heat…
A series of numerical simulations of Rayleigh-B{\'e}nard convection in a cubic cavity are conducted in order to examine the structure of the thermal boundary layer in case of mixed boundary conditions. The main goal of the study is the…