Related papers: Dead-time Compensation Method for Bus-clamping Mod…
A model predictive control (MPC) method for enhancing post-fault transient stability of a grid-forming (GFM) inverter based resources (IBRs) is developed in this paper. This proposed controller is activated as soon as the converter enters…
This paper presents a centralized recursive optimal scheduling method for a battery system that consists of parallel connected battery modules with different open circuit voltages and battery impedance characteristics. Examples of such a…
Power system blackouts are usually triggered by the initial contingency and then deteriorate as the branch outage spreads quickly. Thus, it is crucial to eliminate the propagation of cascading outages in its infancy. In this paper, a model…
This paper addresses the closed-loop ramp comparison current regulation in an induction machine fed by a pulse width modulated voltage source inverter. The regulator is implemented in a synchronous frame, serving as a foundation for an…
The powering range of wireless power transfer (WPT) systems is typically confined to areas close to the transmitter. Shape-reconfigurable two-dimensional (2-D) relay resonator arrays have been developed to extend this range, offering…
This paper provides a simple introduction to pulse width modulation control techniques used for the control of power converters in the context of electric motor drive systems. A summary of each technique is presented along with analytical…
This paper proposes an original solution to input saturation and dead zone of fractional order system. To overcome these nonsmooth nonlinearities, the control input is decomposed into two independent parts by introducing an intermediate…
Inverter-interfaced microgrids, owing to the lack of fault current, cannot be protected using traditional over-current protections, while admittance or differential relaying protection schemes are not practical to be implemented. Dynamic…
In this paper, we propose a complete synchronization algorithm for continuous phase modulation (CPM) signals in burst-mode transmission over additive white Gaussian noise (AWGN) channels. The timing and carrier recovery are performed…
This article is the second part of a paper series about interference in extremum (i.e., peak or valley) current-mode control, which applies to both fixed and variable switching frequency power converters. Specifically, this part presents…
In this paper we consider the problem of voltage regulation of a proton exchange membrane fuel cell connected to an uncertain load through a boost converter. We show that, in spite of the inherent nonlinearities in the current-voltage…
Synchronization instability of grid-tied converters during grid faults is a serious concern. For phase-locked loop (PLL) synchronized converters, synchronization stability during grid faults requires that PLL can resynchronize with the…
This letter proposes a targeted-subharmonic-eliminating pulse density modulation (TSE-PDM) method for SS- compensated WPT systems. By designing a noise transfer function with notch characteristics, the subharmonic components which excite…
Conventionally, the dynamic state estimation of variables in power networks is performed based on the forecasting-aided model of bus voltages. This approach is effective in the stiff grids at the transmission level, where the bus voltages…
This paper summarizes the electromagnetic time reversal (EMTR) technique for fault location, and further numerically validates its effectiveness when the fault impedance is negligible. In addition, a specific EMTR model considering the…
Due to the increasing load demand, the operating state of modern power systems are become closing to their critical levels. Moreover, the modern power systems are integrated with a large amount of fast-response dynamic elements, so the…
This paper presents an improved secondary voltage control (SVC) methodology incorporating compressive sensing (CS) for a multi-area power system. SVC minimizes the voltage deviation of the load buses while CS deals with the problem of the…
We present a method to design distributed generation and demand control schemes for primary frequency regulation in power networks that guarantee asymptotic stability and ensure fairness of allocation. We impose a passivity condition on net…
For the first time, intermodulation distortion of micro-electromechanical capacitive switches in the actuated state was analyzed both theoretically and experimentally. The distortion, although higher than that of switches in the suspended…
This paper presents a sub-switching period current-limiting control for a grid-tied inverter to prevent transient overcurrents during grid faults and enable seamless fault ride-through (FRT). Sudden grid-voltage disturbances, such as…