Related papers: Optimal two-dimensional roughness for transition d…
In this paper, we investigate the effect of boundary surface roughness on numerical simulations of incompressible fluid flow past a cylinder in two and three spatial dimensions furnished with slip boundary conditions. The governing…
Transition and turbulence production in a hypersonic boundary layer is investigated in a Mach 6 quiet wind tunnel using Rayleigh-scattering visualization, fast-response pressure measurements, and particle image velocimetry. It is found that…
The new mode of instability found by Tunney et al. is studied with viscous stability theory in this article. When the high-speed boundary layer is subject to certain values of favorable pressure gradient and wall heating, a new mode becomes…
Turbulent flows above a solid surface are characterised by a hydrodynamic roughness that represents, for the far velocity field, the typical length scale at which momentum mixing occurs close to the surface. Here, we are theoretically…
Turbulence modeling has the potential to revolutionize high-speed vehicle design by serving as a co-equal partner to costly and challenging ground and flight testing. However, the fundamental assumptions that make turbulence modeling such…
Distributed roughness occurs on aerodynamic surfaces like wind/gas turbine blades and aircraft wings causing early boundary layer transition resulting in a reduction of the lift-to-drag ratio/power production. Despite being a recurring…
Optimal transitional mechanisms are analysed for an incompressible shear layer developing over a short, pressure gradient-induced laminar separation bubble (LSB) with peak reversed flow of 2%. Although the bubble remains globally stable,…
The objective of this work is to investigate the unexplored laminar-to-turbulent transition of a heated flat-plate boundary layer with a fluid at supercritical pressure. Two temperature ranges are considered: a subcritical case, where the…
Extensive studies have investigated the transition mechanism of boundary layers initiated by a single primary instability. In a real-world scenario, however, multiple primary instabilities of different physical nature would coexist and…
Direct Numerical Simulations (DNS) of turbulent channel flow at a shear Reynolds number of $Re_{*}=360$ for Newtonian and Herschel-Bulkley fluids in smooth and rough channels has been performed. The rough surface was made of irregular…
We theoretically investigate the pattern formation observed when a fluid flows over a solid substrate that can dissolve or melt. We use a turbulent mixing description that includes the effect of the bed roughness. We show that the…
We revisit here the stability of a deformable interface that separates a fully-developed turbulent gas flow from a thin layer of laminar liquid. Unlike previous work, the turbulent base state velocity profile proposed here requires only a…
High-speed boundary-layer transition is extremely sensitive to the free-stream disturbances which are often uncertain. This uncertainty compromises predictions of models and simulations. To enhance the fidelity of simulations, we directly…
Laminar-turbulent transition in shock wave-boundary-layer interactions (SWBLI) remains a major challenge for hypersonic vehicle design, with implications for drag, heat transfer, and structural loads. Linear optimal perturbation analyses…
This experimental and numerical study examines transition to turbulence for a Cone-Cylinder-Flare geometry at Mach 7 and across a broad Reynolds number range. The focus is set on both attached boundary layers and separated shock-boundary…
Laminar-turbulent transition on a rotating wind turbine blade at a chord Reynolds number of $1 \times 10^5$ and varying angles of attack ($AoA$) is studied with direct numerical simulations and linear stability theory. The rotation effects…
In the context of subaqueous ripple and dune formation, we present here a Reynolds averaged calculation of the turbulent flow over a topography. We perform a weakly non-linear expansion of the velocity field, sufficiently accurate to…
Boundary layer flow over a realistic porous wall might contain both the effects of wall-permeability and wall-roughness. These two effects are typically examined in the context of a rough-wall flow, i.e., by defining a ``roughness'' length…
This work considers the transition to unsteadiness in the wake of 2D slender bodies, and questions the relevance of the generally accepted scenario involving a region of absolute instability within the near wake. The case of a thin plate at…
The flow of the laminar boundary layer on a flat plate is studied with simulation of Navier-Stokes equations. The mechanisms of flow instability at external edge of the boundary layer and near the wall are analyzed using the energy gradient…