Related papers: Pose Graph Optimization for a MAV Indoor Localizat…
Recent advances in LiDAR technology have opened up new possibilities for robotic navigation. Given the widespread use of occupancy grid maps (OGMs) in robotic motion planning, this paper aims to address the challenges of integrating LiDAR…
Millimeter-wave (mmWave) and terahertz (THz) communication systems typically deploy large antenna arrays to guarantee sufficient receive signal power. The beam training overhead associated with these arrays, however, make it hard for these…
Unmanned aerial vehicle (UAV)-based base stations offer a promising solution in emergencies where the rapid deployment of cutting-edge networks is crucial for maximizing life-saving potential. Optimizing the strategic positioning of these…
3GPP Release 19 has initiated the standardization of integrated sensing and communications (ISAC), including a channel model for monostatic sensing, evaluation scenarios, and performance assessment methodologies. These common assumptions…
This paper proposes a new image-based localization framework that explicitly localizes the camera/robot by fusing Convolutional Neural Network (CNN) and sequential images' geometric constraints. The camera is localized using a single or few…
This paper proposes a low-cost six Degree-of-Freedom (6-DOF) navigation system for small aerial robots based on the integration of Global Position System (GPS) receiver with sensors of inertional Microelectromechanical Systems (MEMS). In…
We present a synchronized multisensory dataset for accurate and robust indoor localization: the Lund University Vision, Radio, and Audio (LuViRA) Dataset. The dataset includes color images, corresponding depth maps, inertial measurement…
Angle of arrival (AOA) is widely used to locate a wireless signal emitter in unmanned aerial vehicle (UAV) localization. Compared with received signal strength (RSS) and time of arrival (TOA), it has higher accuracy and is not sensitive to…
We introduce a new graph neural operator-based approach for task allocation in a system of heterogeneous robots composed of Unmanned Ground Vehicles (UGVs) and Unmanned Aerial Vehicles (UAVs). The proposed model, \texttt{\method}, or…
Localizing mobile robotic nodes in indoor and GPS-denied environments is a complex problem, particularly in dynamic, unstructured scenarios where traditional cameras and LIDAR-based sensing and localization modalities may fail.…
This work performs the design, real-time hardware realization, and experimental evaluation of a positioning system by ultra-violet (UV) communication under photon-level signal detection. The positioning is based on time-difference of…
Reliable positioning in dense urban environments remains challenging due to frequent GNSS signal blockage, multipath, and rapidly varying satellite geometry. While factor graph optimization (FGO)-based GNSS-IMU fusion has demonstrated…
This paper presents a novel approach for predicting human poses using IMU data, diverging from previous studies such as DIP-IMU, IMUPoser, and TransPose, which use up to 6 IMUs in conjunction with bidirectional RNNs. We introduce two main…
Micro Air Vehicles (MAVs) will unlock their true potential once they can operate in groups. To this end, it is essential for them to estimate on-board the relative location of their neighbors. The challenge lies in limiting the mass and…
Drones may be more advantageous than fixed cameras for quality control applications in industrial facilities, since they can be redeployed dynamically and adjusted to production planning. The practical scenario that has motivated this…
Nano-sized unmanned aerial vehicles (UAVs) are well-fit for indoor applications and for close proximity to humans. To enable autonomy, the nano-UAV must be able to self-localize in its operating environment. This is a…
For precise, efficient, and safe drone landings, ground platforms should real-time, accurately locate descending drones and guide them to designated spots. While mmWave sensing combined with cameras improves localization accuracy, lower…
We present Acoustic Inertial Measurement (AIM), a one-of-a-kind technique for indoor drone localization and tracking. Indoor drone localization and tracking are arguably a crucial, yet unsolved challenge: in GPS-denied environments,…
The adoption of Unmanned Aerial Vehicles (UAVs) for public safety applications has skyrocketed in the last years. Leveraging on Physical Random Access Channel (PRACH) preambles, in this paper we pioneer a novel localization technique for…
Multi-Unmanned Aerial Vehicle (UAV) Networks is a promising solution to providing wireless coverage to ground users in challenging rural areas (such as Internet of Things (IoT) devices in farmlands), where the traditional cellular networks…