Related papers: Code Optimization and Angle-Doppler Imaging for ST…
In this paper, we present a space-time-frequency joint block coding (STFBC) scheme to exploit the essential space-time-frequency degrees of freedom of multiuser MISO-MC-CDMA systems. Specifically, we use a series of orthogonal random codes…
Blind algorithms for multiple-input multiple-output (MIMO) signals interception have recently received considerable attention because of their important applications in modern civil and military communication fields. One key step in the…
Dual-function radar-communication (DFRC), which can simultaneously perform both radar and communication functionalities using the same hardware platform, spectral resource and transmit waveform, is a promising technique for realizing…
Matrix multiplication is a core operation in numerous applications, yet its exact computation becomes prohibitively expensive as data scales, especially in streaming environments where timeliness is critical. In many real-world scenarios,…
The 3D MIMO code is a robust and efficient space-time block code (STBC) for the distributed MIMO broadcasting but suffers from high maximum-likelihood (ML) decoding complexity. In this paper, we first analyze some properties of the 3D MIMO…
In Multi-Input Multi-Output (MIMO) systems, Maximum-Likelihood (ML) decoding is equivalent to finding the closest lattice point in an N-dimensional complex space. In general, this problem is known to be NP hard. In this paper, we propose a…
Target parameter estimation performance is investigated for a radar employing a set of widely separated transmitting and receiving antenna arrays. Cases with multiple extended targets are considered under two signal model assumptions:…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
There is a demand for the same data content from several user equipments (UEs) in many wireless communication applications. Physical-layer multicasting combines the beamforming capability of massive MIMO (multiple-input multiple-output) and…
This letter describes how to improve performance of cellular systems by combining non-equiprobable signaling (shaping) with low-density parity check (LDPC) coding for an orthogonal frequency division multiplexing system. We focus on…
This paper presents a multi-objective stochastic optimization method for tuning of the controller parameters of Refrigeration Systems based on Vapour Compression. Stochastic Multi Parameter Divergence Optimization (SMDO) algorithm is…
The construction of optimal linear block error-correcting codes is not an easy problem, for this, many studies describe methods for generating good error correcting codes in terms of minimum distance. In a previous work, we have presented…
Multiple-input multiple-output (MIMO) technology applied with orthogonal frequency division multiplexing (OFDM) is considered as the ultimate solution to increase channel capacity without any additional spectral resources. At the receiver…
Massive multiple-input multiple-output (M-MIMO) is an enabling technology of 5G wireless communication. The performance of an M-MIMO system is highly dependent on the speed and accuracy of obtaining the channel state information (CSI). The…
This paper investigates the problem of hybrid precoder and combiner design for multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems operating in millimeter-wave (mmWave) bands. We propose a novel…
Complex ADMM-Net, a complex-valued neural network architecture inspired by the alternating direction method of multipliers (ADMM), is designed for interference removal in super-resolution stepped frequency radar angle-range-doppler imaging.…
To combine the power efficiency of Continuous Phase Modulation (CPM) with enhanced performance in fading environments, some authors have suggested to use CPM in combination with Space-Time Codes (STC). Recently, we have proposed a CPM…
The use of low-precision analog-to-digital converters (ADCs) is a low-cost and power-efficient solution for a millimeter wave (mmWave) multiple-input multiple-output (MIMO) system operating at sampling rates higher than a few Gsample/sec.…
This paper presents a novel approach to enhance Model Predictive Control (MPC) for legged robots through Distributed Optimization. Our method focuses on decomposing the robot dynamics into smaller, parallelizable subsystems, and utilizing…
Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems typically employ hybrid mixed signal processing to avoid expensive hardware and high training overheads. {However, the lack of fully digital beamforming at…