Related papers: 3D Microstructural and Strain Evolution During the…
We first report a detailed transmission electron microscopy study of dislocation networks (DNs) formed at shallowly buried interfaces obtained by bonding two GaAs crystals between which we establish in a controlled manner a twist and a tilt…
Plasticity in hexagonal close packed (HCP) metals and alloys such as Titanium (Ti) and Zirconium (Zr) is carried out by the motion of $\langle a \rangle$ dislocations. Above room temperature, in situ transmission electron microscopy…
Three-dimensional X-ray diffraction (3DXRD) has been used to measure, in-situ, the evolution of $\sim 1800$ grains in a single phase low carbon ferritic steel sample during uniaxial deformation. The distribution of initial residual grain…
Plastic deformation of crystals is a physical phenomenon, which has immensely driven the development of human civilisation since the onset of the Chalcolithic period. This process is primarily governed by the motion of line defects, called…
This work deals with an investigation of general principles of superplasticity (SP) in deformed materials. It is shown that a non-linear, wave plastic deformation is the basic process for all plastic deformation phenomena, it makes an…
Crystalline materials deform in an intermittent way via dislocation-slip avalanches. Below a critical stress, the dislocations are jammed within their glide plane due to long-range elastic interactions and the material exhibits plastic…
Our understanding of the elasticity and rheology of disordered materials, such as granular piles, foams, emulsions or dense suspensions relies on improving experimental tools to characterize their behaviour at the particle scale. While 2D…
Dislocation-density-based crystal plasticity (CP) models are introduced to account for the microstructural changes throughout the deformation process, enabling more quantitative predictions of the deformation process compared to slip-system…
Plastic deformation of microsamples is characterised by large intermittent strain bursts caused by dislocation avalanches. Here we investigate how ion irradiation affects this phenomenon during single slip single crystal plasticity. To this…
We demonstrate that plastic deformation in solids is associated with a dynamic transition that is reminiscent to the transition from a superconducting to a mixed phase in Type II superconductors. We report analytic calculations, extensive…
We study a continuous quasi-two-dimensional order-disorder phase transition that occurs in a simple model of a material that is inhomogeneously strained due to the presence of dislocation lines. Performing Monte Carlo simulations of…
We conduct dislocation dynamics (DD) simulations of Fe periodic single crystals under tensile load at several high strain rates and temperatures. The simulations are enabled by the recent development of temperature-dependent dislocation…
A mesoscale study of a single crystal nickel-base superalloy subjected to an industrially relevant process simulation has revealed the complex interplay between microstructural development and the micromechanical behaviour. As sample gauge…
Nanodot deposition on a side surface of a rectangular sample and digital image correlation are used to quantify the in-plane strain fields associated with the propagation of a shear band in a PdNiP bulk metallic glass,induced by rolling.…
Results from 2.5D and 3D studies of the onset and development of the tearing instability are presented, using high fidelity resistive MHD simulations. A limited parameter study of the strength of the reconnecting field (or shear angle) was…
Understanding mechanical properties of materials requires not only complete determination of the three-dimensional response at a local scale, but also knowledge of the mode or the mechanism by which deformation takes place. Probing…
We develop a simple computational model for cell boundary evolution in plastic deformation. We study the cell boundary size distribution and cell boundary misorientation distribution that experimentally have been found to have scaling forms…
The use of Nye's dislocation tensor for calculating the density of geometrically necessary dislocations (GND) is widely adopted in the study of plastically deformed materials. The curl operation involved in finding the Nye tensor, while…
The field of two-dimensional (2D) materials has expanded to multilayered systems where electronic, optical, and mechanical properties change-often dramatically-with stacking order, thickness, twist, and interlayer spacing [1-5]. For…
The internal energy associated with the defect microstructure of strongly deformed crystals provides an important driving force for grain boundary motion during recrystallization. Typical dislocation microstructures are strongly…