Related papers: Broadband Bandpass Purcell Filter for Circuit Quan…
Coupling a resonator to a superconducting qubit enables various operations on the qubit, including dispersive readout and unconditional reset. The speed of these operations is limited by the external decay rate of the resonator. However,…
The ability to perform fast, high-fidelity readout of quantum bits (qubits) is essential to the goal of building a quantum computer. However, coupling a fast measurement channel to a superconducting qubit typically also speeds up its…
The speed of quantum gates and measurements is a decisive factor for the overall fidelity of quantum protocols when performed on physical qubits with finite coherence time. Reducing the time required to distinguish qubit states with high…
We present a superconducting device that realizes the sequential measurement of a transmon qubit. The device disables common limitations of dispersive readout such as Purcell effect or transients in the cavity mode by turning on and off the…
To control and measure the state of a quantum system it must necessarily be coupled to external degrees of freedom. This inevitably leads to spontaneous emission via the Purcell effect, photon-induced dephasing from measurement back-action,…
Achieving high-fidelity qubit readout and reset while preserving qubit coherence is essential for quantum error correction and other advanced quantum algorithms. Here, we design and experimentally demonstrate a scalable architecture…
The speed and fidelity of dispersive readout of superconducting qubits should improve by increasing the amplitude of the measurement drive. Experiments show, however, that beyond some drive amplitude there is always a saturation or drop in…
Circuit quantum electrodynamics (QED) employs superconducting microwave resonators as quantum buses. In circuit QED with semiconductor quantum-dot-based qubits, increasing the resonator impedance is desirable as it enhances the coupling to…
Superconducting electrical circuits can be used to study the physics of cavity quantum electrodynamics (QED) in new regimes, therefore realizing circuit QED. For quantum information processing and quantum optics, an interesting regime of…
We introduce a frequency-multiplexed readout scheme for superconducting phase qubits. Using a quantum circuit with four phase qubits, we couple each qubit to a separate lumped-element superconducting readout resonator, with the readout…
Dispersive coupling based on the Rabi model with large detuning is widely used for quantum nondemolition (QND) qubit readout in quantum computation. However, the measurement speed and fidelity are usually significantly limited by the…
We consider continuous quantum measurement of a superconducting qubit in the circuit QED setup with a moderate bandwidth of the measurement resonator, i.e., when the "bad cavity" limit is not applicable. The goal is a simple description of…
The measurement of a superconducting qubit is implemented by coupling it to a resonator. The common choice is transverse coupling, which, in the dispersive approximation, introduces an interaction term which enables the measurement. This…
Quantum error correction protocols require rapid and repeated qubit measurements. While multiplexed readout in superconducting quantum systems improves efficiency, fast probe pulses introduce spectral broadening, leading to signal leakage…
We investigate the effect of a waveguide on an emitter spontaneous emission in its vicinity. The impact of various possible orientations of an emitter with respect to the waveguide surface is studied through simulations and compared with…
The duration and fidelity of qubit readout is a critical factor for applications in quantum information processing as it limits the fidelity of algorithms which reuse qubits after measurement or apply feedback based on the measurement…
A new type of low-pass filter based on a leaky coaxial waveguide is presented. The filter has minimal insertion loss in the pass band, while at the same time high attenuation in the stop band is achieved. Thanks to its arrangement, the…
The light emission rate of a single quantum dot can be drastically enhanced by embedding it in a resonant semiconductor microcavity. This phenomenon is known as the Purcell effect, and the coupling strength between emitter and cavity can be…
We present a simple formalism describing evolution of a qubit in the process of its measurement in a circuit QED setup. When a phase-sensitive amplifier is used, the evolution depends on only one output quadrature, and the formalism is the…
By modeling the coupling of multiple superconducting qubits to a single cavity in the circuit-quantum electrodynamics (QED) framework we find that it should be possible to observe superradiance and phase multistability using currently…