Related papers: Practical Channel Splicing using OFDM Waveforms fo…
Future wireless communication systems must simultaneously address multiple challenges to ensure accurate data detection, deliver high Quality of Service (QoS), adding enable a high data transmission with low system design. Additionally,…
Intelligent reflecting surface (IRS), composed of a large number of hardware-efficient passive elements, is deemed as a potential technique for future wireless communications since it can adaptively enhance the propagation environment. In…
Integrated sensing and communications (ISAC) as one of the key technologies is capable of supporting high-speed communication and high-precision sensing for the upcoming 6G. This paper studies a waveform strategy by designing the orthogonal…
The dominating waveform in 5G is orthogonal frequency division multiplexing (OFDM). OFDM will remain a promising waveform candidate for joint communication and sensing (JCAS) in 6G since OFDM can provide excellent data transmission…
This paper addresses the problem of estimating sparse channels in massive MIMO-OFDM systems. Most wireless channels are sparse in nature with large delay spread. In addition, these channels as observed by multiple antennas in a neighborhood…
In this paper, we investigate the issue of integrated sensing, computation and communication (SCC) in beyond fifth-generation (B5G) cellular internet of things (IoT) networks. According to the characteristics of B5G cellular IoT, a…
This article presents our initial results in deep learning for channel estimation and signal detection in orthogonal frequency-division multiplexing (OFDM). OFDM has been widely adopted in wireless broadband communications to combat…
Channel sounding is a vital step in understanding wireless channels for the design and deployment of wireless communication systems. In this paper, we present the design and implementation of a coherent distributed massive MIMO channel…
Integrated sensing and communication (ISAC) is a key enabler for future radio networks. This paper presents a sub-band full-duplex (SBFD) ISAC system that assigns non-overlapping OFDM subbands to sensing and communication, enabling…
Uplink sensing is still a relatively unexplored scenario in integrated sensing and communication which can be used to improve positioning and sensing estimates. We introduce a pilot-based maximum likelihood, and a maximum a posteriori…
This paper tackles the challenge of wideband MIMO channel estimation within indoor millimeter-wave scenarios. Our proposed approach exploits the integrated sensing and communication paradigm, where sensing information aids in channel…
Recently, the paradigm of massive ultra-reliable low-latency IoT communications (URLLC-IoT) has gained growing interest. Reliable delay-critical uplink transmission in IoT is a challenging task since low-complex devices typically do not…
For an orthogonal frequency-division multiplexing (OFDM) system over a doubly selective (DS) channel, a large number of pilot subcarriers are needed to estimate the numerous channel parameters, resulting in low spectral efficiency. In this…
Multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems rely on digital or hybrid digital and analog designs for beamforming against frequency-selective fading, which suffer from high hardware…
The significance of distributed learning and inference algorithms in Internet of Things (IoT) network is growing since they flexibly distribute computation load between IoT devices and the infrastructure, enhance data privacy, and minimize…
Integrated sensing and communication (ISAC) has garnered significant attention in recent years. In this paper, we delve into the topic of sensing-assisted communication within ISAC systems. More specifically, a novel sensing-assisted…
Interference alignment (IA) has been shown to achieve the maximum achievable degrees of freedom in the interference channel. This results in sum rate scaling linearly with the number of users in the high signal-to-noise-ratio (SNR) regime.…
The Internet of Things (IoT) could enable the development of cloud multiple-input multiple-output (MIMO) systems where internet-enabled devices can work as distributed transmission/reception entities. We expect that spatial multiplexing…
Wireless Fidelity (Wi-Fi) communication technologies hold significant potential for realizing the Industrial Internet of Things (IIoT). In this paper, both Single-Input Single-Output (SISO) and polarized Multiple-Input Multiple-Output…
The ongoing convergence of spectrum and hardware requirements for wireless sensing and communication applications has fueled the integrated sensing and communication (ISAC) paradigm in next-generation networks. Neural-network-based ISAC…