Related papers: Experiment-based model of Er/Yb gain medium for fi…
This study presents the development of two graphical interfaces using Matlab's graphical user interface tool, GUIDE, to model the steady-state and dynamic responses of Erbium (Er$^{3+}$)-doped fiber amplifiers. The primary focus is on their…
Using a numerical model we study the frequency dependence of mode coupling gain due to stimulated thermal Rayleigh scattering in step index, Yb doped, fiber amplifiers. The frequency at the gain peak is shown to vary with core size, doping…
Multimode fibers have been proposed for mitigating nonlinear effects in high-power fiber amplifiers, allowing for significant power scaling. Most previous studies on light propagation in continuous-wave fiber amplifiers focus on single mode…
The enhancement of Er$^{3+}$-based up-conversion for photovoltaics in multilayer porous silicon photonic structures is considered theoretically and experimentally. Transfer matrix simulations are used to assess the increased photonic…
Erbium-Doped Fiber Amplifiers can present holes in spectral gain in Wavelength Division Multiplexing operation. The origin of this inhomogeneous saturation behavior is still a subject of controversy. In this paper we present both an…
Media featuring both optical gain and disorder, such as random lasers, represent formidable challenges as subjects of research due to the high complexity of the light propagation within them; however, dramatic advances in this nascent field…
An analytically expression for the temperature dependence of the signal gain of an erbium-doped fiber amplifier (EDFA) pumped at 1480 \textit{nm} are theoretically obtained by solving the propagation equations with the amplified spontaneous…
We propose an energy transfer model with a cubic atomic population dependence to accurately model the behavior of various reported high-power erbium-doped fluoride fiber lasers operating near 2.8 microns. We first show that the previously…
Dependence of mode instabilities (MI) on ytterbium dopant concentrations in high power fiber amplifiers has been investigated. It is theoretically shown that, by only varying the fiber length to maintain the same total small-signal pump…
The dependence of the relative population inversion in Er3+-doped fiber amplifiers (EDFAs) upon temperature and cross sections, taking into account the amplified spontaneous emission (ASE), are investigated theoretically by the modified…
A new class of Erbium doped glasses with compositions xNa2O - (60-x)PbCl2 - 40P2O5 (x=0, 10, 20 and 30) were fabricated and characterized for optical properties. Absorption spectra were analyzed for important Judd-Ofelt parameters from the…
An efficient method to fabricate transparent glass ceramic fibers containing in-situ grown Er3+-doped oxide nanoparticles is presented. Characterization of the drawn fibers exhibits low loss (0.4 dB/m) and broadened Er3+ emission spectrum.…
We present both modeling and computational advancements to a unique three-dimensional discontinuous Petrov-Galerkin finite element model for the simulation of laser amplification in a fiber amplifier. Our model is based on the time-harmonic…
We show by numerical modeling that saturation of the population inversion reduces the stimulated thermal Rayleigh gain relative to the laser gain in large mode area fiber amplifiers. We show how to exploit this effect to raise mode…
On-chip erbium-doped optical amplifiers and lasers are essential for realizing fully integrated active silicon photonic circuits, but their performance has been limited by the low gain of amorphous host materials and the difficulty of…
The upconversion process for the $Er^{3+}$ ion, when irradiated with IR photons at 980 nm, strongly depends upon the presence of the sensitizer $Yb^{3+}$ ions. There is a good correlation between the relative and absolute concentrations of…
We report on the use of Z-scan technique with a beam composed with two modes, to probe the nonlinear optical properties of phosphate glasses doped with Er$^{3+}$-Yr$^{3+}$ and silver nanoparticles. Understanding the linear and nonlinear…
Here, we demonstrate all-fiber direct amplification of 11 picosecond pulses from a gain-switched laser diode at 1063nm. The diode was driven at a repetition rate of 40MHz and delivered 13$\mu$W of fiber-coupled average output power. For the…
Erbium (Er) ions are the gain medium of choice for fiber-based amplifiers and lasers, offering a long excited-state lifetime, slow gain relaxation, low amplification nonlinearity and noise, and temperature stability compared to…
The upconversion process for the $Er^{3+}$ ion, when irradiated with IR photons at 980 nm, strongly depends upon the presence of the sensitizer $Yb^{3+}$ ions. There are many studies analyzing the properties of the upconversion process for…