Related papers: Qubit readouts enabled by qubit cloaking
Cavity quantum electrodynamics (QED) uses a cavity to engineer the mode structure of the vacuum electromagnetic field such as to enhance the interaction between light and matter. Exploiting these ideas in solid-state systems has lead to…
We devise a Floquet theory of longitudinal and dispersive readout in circuit QED. By studying qubits coupled to cavity photons and driven at the resonance frequency of the cavity $\omega_{\rm r}$, we establish a universal connection between…
We propose a method for the measurement of adiabatic phases of periodically driven quantum systems coupled to an open cavity that enables dispersive readout. It turns out that the cavity transmission exhibits peaks at frequencies determined…
The performance of a wide range of quantum computing algorithms and protocols depends critically on the fidelity and speed of the employed qubit readout. Examples include gate sequences benefiting from mid-circuit, real-time,…
Properties of time-periodic Hamiltonians can be exploited to increase the dephasing time of qubits and to design protected one and two-qubit gates. Recently, Huang et al. [Phys. Rev. Applied 15, 034065 (2021)] have shown that time-dependent…
We present a unified picture of dispersive readout of quantum systems in and out of equilibrium. A cornerstone of the approach is the backaction of the measured system to the cavity obtained with non-equilibrium linear-response theory. It…
We show how to realize high-fidelity quantum non-demolition qubit readout using longitudinal qubit-oscillator interaction. This is realized by modulating the longitudinal coupling at the cavity frequency. The qubit-oscillator interaction…
The speed and fidelity of dispersive readout of superconducting qubits should improve by increasing the amplitude of the measurement drive. Experiments show, however, that beyond some drive amplitude there is always a saturation or drop in…
Dispersive readout is widely used to perform high-fidelity measurement of superconducting qubits. Much work has been focused on the qubit readout fidelity, which depends on the achievable signal-to-noise ratio and the qubit relaxation time.…
Interfacing stationary qubits with propagating photons is a fundamental problem in quantum technology. Cavity quantum electrodynamics (CQED) invokes a mediator degree of freedom in the form of a far-detuned cavity mode, the adaptation of…
We show how to use two-mode squeezed light to exponentially enhance cavity-based dispersive qubit measurement. Our scheme enables true Heisenberg-limited scaling of the measurement, and crucially, is not restricted to small dispersive…
For some cavity-quantum-electrodynamics systems, such as a single electron spin coupled to a passive cavity, it is challenging to reach the strong-coupling regime. In such a weak-coupling regime, the conventional dispersive readout…
Superconducting electrical circuits can be used to study the physics of cavity quantum electrodynamics (QED) in new regimes, therefore realizing circuit QED. For quantum information processing and quantum optics, an interesting regime of…
The dispersive coupling between a qubit and a cavity mode is widely used for performing non-destructive readout of the qubit state. In this approach, it is typically required that the dispersive strong coupling regime is achieved. Here we…
We introduce and analyze a dispersive qubit readout scheme where two-mode squeezing is generated directly in the measurement cavities. The resulting suppression of noise enables fast, high- fidelity readout of naturally weakly coupled…
Readout of superconducting qubits faces a trade-off between measurement speed and unwanted back-action on the qubit caused by the readout drive, such as $T_1$ degradation and leakage out of the computational subspace. The readout is…
We propose a generalisation of dispersive qubit readout which provides the time evolution of a flux qubit observable. Our proposal relies on the non-linear coupling of the qubit to a harmonic oscillator with high frequency, representing a…
Frequency-multiplexing is an effective method to achieve resource-efficient superconducting qubit readout. Allowing multiple resonators to share a common feedline, the number of cables and passive components involved in the readout of a…
The dispersive-readout scheme enables quantum nondemolition measurement of superconducting qubits. An increased readout power can shorten the readout time and reduce the state discrimination error but can promote qubit transitions into…
Entangling superconducting quantum processors via light would enable new means of secure communication and distributed quantum computing. However, transducing quantum signals between these disparate regimes of the electromagnetic spectrum…