Related papers: Active flow control over a finite wall-mounted squ…
In this paper, we present the results of a numerical study of air-water turbulent bubbly flow in a periodic vertical square duct. The study is conducted using a novel numerical technique which leverages Volume of Fluid method for interface…
We study the effects of fluid-particle and particle-particle interactions in a three-dimensional monodispersed reactor with unstable fluidization. Simulations were conducted using the Immersed Boundary Method (IBM) for particle Reynolds…
The atmospheric plasma is regarded as an effective method for surface treatments because it can reduce the period of process and does not need expensive vacuum apparatus. The performance of non-transferred plasma torches is significantly…
An increasing integration of photovoltaic units, electric vehicle chargers, heat pumps, and energy storage systems challenges low-voltage power grids and can cause voltage range violation, loss of stability, (local) overload of lines, and…
This study explores the application of a wall-attached ferrofluid film to decrease skin friction drag in turbulent channel flow. We conduct experiments using water as a working fluid in a turbulent channel flow setup, where one wall is…
Many experimental and numerical studies report a large reduction of the recirculation bubble in Backward-Facing Step flows or airfoils in stall situation when excited at the natural shedding frequency $f_0$. Through a simple experiment…
To bridge the gap between high and low fidelity numerical modeling tools for vertical-axis (or cross-flow) turbines (VATs or CFTs), an actuator line model (ALM) was developed and validated for both a high and a medium solidity vertical-axis…
An elastic foil interacting with a uniform flow with its trailing edge clamped, also known as the inverted foil, exhibits a wide range of complex self-induced flapping regimes such as large amplitude flapping (LAF), deformed and flipped…
Surface dielectric barrier discharge (SDBD) actuators driven by the Pulsed-DC voltages are analyzed. The Pulsed-DC SDBD studied in this work is equivalent to a classical SDBD driven by a tailored Fast-Rise-Slow-Decay (FRSD) voltage…
Airflow simulation results depend on a good prediction of near wall turbulence. In this paper a comparative study between different near wall treatments is presented. It is applied to two test cases: (1) the first concerns the fully…
Flow control aims at modifying a natural flow state to reach an other flow state considered as advantageous. In this paper, active feedback flow separation control is investigated with two different closed-loop control strategies, involving…
We consider linear feedback control of the two-dimensional flow past a cylinder at low Reynolds numbers, with a particular focus on the optimal placement of a single sensor and a single actuator. To accommodate the high dimensionality of…
Closed-loop control of an amplifier flow is experimentally investigated. A feed-forward algorithm is implemented to control the flow downstream a backward-facing step. Upstream and downstream data are extracted from real-time velocity…
An experimental study was conducted in the CICLoPE long-pipe facility to investigate the correlation between wall-pressure and turbulent velocity fluctuations in the logarithmic region, at high friction Reynolds numbers ($4\,794 \lesssim…
We combine three-dimensional (3D) large-eddy simulations (LES) and resolvent analysis to design active separation control techniques on a NACA 0012 airfoil. Spanwise-periodic flows over the airfoil at a chord-based Reynolds number of…
This paper numerically investigates the influence of a fixed downstream control cylinder on the flow-induced vibration of an elastically-supported primary cylinder. These two cylinders are situated in a tandem arrangement with small…
The impact of fluidic actuation on the wake and drag of a three-dimensional blunt body is investigated experimentally. Jets blowing tangentially to the main flow allow to force the wake with variable frequency and amplitude. Depending on…
Fluid simulations, which are considerably simpler and faster, have been employed to study the behavior of the wakefield driven by a relativistic rigid beam in a 2-D cold plasma. When the transverse dimensions of the beam are chosen to be…
A variational technique is used to derive analytical expressions for the sensitivity of several geometric indicators of flow separation to steady actuation. Considering the boundary layer flow above a wall-mounted bump, the six following…
Flow generated noise are caused shear flows and, hence, they can be used as feedback to control the flow. Existing flow control uses state variables like velocity, pressure, or vorticity, none use acoustic observables as the primary control…