Related papers: Real-time buffer gas pressure tuning in a micro-ma…
Positive streamers in ambient air at pressures from 0.013 to 1 bar are investigated experimentally. The voltage applied to the anode needle ranges from 5 to 45 kV, the discharge gap from 1 to 16 cm. Using a "slow" voltage rise time of 100…
We describe a simple strontium vapor cell for laser spectroscopy experiments. Strontium vapor is produced using an electrically heated commercial dispenser source. The sealed cell operates at room temperature, and without a buffer gas or…
Rydberg atomic sensors offer transformative potential for high-speed, high-sensitivity terahertz (THz) imaging. However, previous systems are hindered by restricted imaging areas, largely due to the compact dimension of atomic vapor cells…
Determination of air density and the quantitative estimates of water vapour adsorbed or desorbed by the surface of mass standard, remain the principals sources of uncertainties when weighing mass standard made from stainless steel or super…
Boiling crisis experiments are carried out in the vicinity of the liquid-gas critical point of H2. A magnetic gravity compensation setup is used to enable nucleate boiling at near critical pressure. The measurements of the critical heat…
We have designed and constructed an experimental system to study gas bubble growth in slightly supersatu- rated liquids. This is achieved by working with carbon dioxide dissolved in water, pressurized at a maximum of 1 MPa and applying a…
Ac electrokinetic flows are commonly used for manipulating micron-scale particles in a biosensor system. At the solid-liquid state there are two kinds of processes in the reaction between analytes and ligands: the mass transport process and…
Electron self-injection and acceleration until dephasing in the blowout regime is studied for a set of initial conditions typical of recent experiments with 100 terawatt-class lasers. Two different approaches to computationally efficient,…
Gaseous detectors have long been used by particle physics experiments at beamlines or standalone experiments. Recently, their low momentum threshold has made them interesting as active targets for long baseline neutrino experiments. To…
We demonstrate an experimental technique that allows to achieve a robust control on the emission spectrum of a micro random laser and to select individual modes with sub-nanometer resolution. The presented approach relies on an optimization…
We have developed a versatile pulsed laser system for high precision magnetometry. The operating wavelength of the system can be configured to optically pump alkali vapors such as rubidium and cesium. The laser system consists of an…
We demonstrate a technique for obtaining the density of atomic vapor, by doing a fit of the resonant absorption spectrum to a density-matrix model. In order to demonstrate the usefulness of the technique, we apply it to absorption in the…
A novel scheme is presented for production of a thin ($<1$ mm) uniform vapor layer over a large surface area ($>100$ cm$^2$) by pulsed laser ablation of a solid surface. Instead of dispersing the laser energy uniformly over the surface, a…
A novel micromixing technique that exploit a thrust of droplets into the mixing interface is developed. The technique enhances the mixing by injecting immiscible droplets in a mixing channel and the methodology enables a control of the…
The loading dynamics of an alkali-atom magneto-optical trap can be used as a reliable measure of vacuum pressure, with loading time T indicating a pressure less than or equal to [2x10^(-8) Torr s]/T. This relation is accurate to…
Laser-plasma proton acceleration was investigated in the Target Normal Sheath Acceleration (TNSA) regime using a novel gas-foil target. The target is designed for reaching higher laser intensity at the foil plane owing to relativistic…
Chip-scale atomic devices built around micro-fabricated alkali vapor cells are at the forefront of compact metrology and atomic sensors. We demonstrate a micro-fabricated vapor cell that is actively-pumped to ultra-high-vacuum (UHV) to…
We demonstrate and characterize a source of Li atoms made from direct metal laser sintered titanium. The source's outgassing rate is measured to be $5 \,(2)\cdot 10^{-7}$\,$\rm{Pa}~ \rm{L}~ \rm{s}^{-1}$ at a temperature $T=330\,^\circ$C,…
Condensation of a liquid droplet from a supersaturated vapour phase is initiated by a prototypical nucleation event. As such it is challenging to compute its rate from atomistic molecular dynamics simulations. In fact at realistic…
In order to improve the quality of thin film deposition by magnetron discharges, particularly by an effective ionization of the sputtered vapor, we developed an ionized physical vapor deposition method based on pre-ionized pulsed magnetron…