Related papers: A Novel Pre-Coding Based PAPR Reduction Scheme for…
Orthogonal frequency division multiplexing (OFDM) signals have high peak-to-average power ratio (PAPR), which causes distortion when OFDM signal passes through a nonlinear high power amplifier (HPA). A partial transmit sequence (PTS) scheme…
Asymmetrically clipped optical orthogonal frequency-division multiplexing (ACO-OFDM) is a technique that sacrifices spectral efficiency in order to transmit an orthogonally frequency-division multiplexed signal over a unipolar channel, such…
This paper presents performance analysis of an adaptive peak cancellation method to reduce the high peak-toaverage power ratio (PAPR) for OFDM systems, while keeping the out-of-band (OoB) power leakage as well as an in-band distortion power…
Affine frequency division multiplexing (AFDM) is a promising new multicarrier technique for high-mobility communications based on discrete affine Fourier transform (DAFT). By properly tuning two parameters in the DAFT module, the effective…
Visible Light Communication (VLC) technology using light emitting diodes (LEDs) has been gaining increasing attention in recent years as it is appealing for a wide range of applications such as indoor positioning. Orthogonal frequency…
Low peak-to-average power ratio (PAPR) orthogonal frequency division multiplexing (OFDM) waveform design is a crucial issue in integrated sensing and communications (ISAC). This paper introduces an OFDM-ISAC waveform design that utilizes…
Orthogonal frequency-division multiplexing (OFDM) time-domain signals exhibit high peak-to-average (power) ratio (PAR), which requires linear radio-frequency chains to avoid an increase in error-vector magnitude (EVM) and out-of-band (OOB)…
Mixed-numerology transmission is proposed to support a variety of communication scenarios with diverse requirements. However, as the orthogonal frequency division multiplexing (OFDM) remains as the basic waveform, the peak-to average power…
The partial transmit sequence (PTS) technique has received much attention in reducing the high peak to average power ratio (PAPR) of orthogonal frequency division multiplexing (OFDM) signals. However, the PTS technique requires an…
Filter bank multicarrier with offset quadrature amplitude modulation (FBMC-OQAM) is an alternative to OFDM for enhanced spectrum flexible usage. To reduce the peak-to-average power ratio (PAPR), DFT spreading is usually adopted in OFDM…
Orthogonal frequency division multiplexing with index modulation (OFDM-IM) is a novel scheme where the information bits are conveyed through the subcarrier activation pattern (SAP) and the symbols on the active subcarriers. Unfortunately,…
High Peak-to-Average Power Ratio (PAPR) is still a common issue in multicarrier signal modulation systems such as Orthogonal Chirp Division Multiplexing (OCDM) and Affine Frequency Division Multiplexing (AFDM), which are envisioned to play…
OFDM signals demonstrates high fluctuations termed as Peak to Average Power Ratio (PAPR).The problem of OFDM is the frequent occurrence of high Peaks in the time domain signal which in turn reduces the efficiency of transmit high power…
A telecommunication system uses carriers in order to transmit information through a cable or wirelessly. If each time only one carrier is transmitted, then the system s signal will not be immune to frequency selective fading. If frequency…
We address a design of high-capacity and low-peak-to-average power ratio (PAPR) orthogonal frequency-division multiplexing (OFDM) systems based on bit-interleaved coded modulation (BICM) utilizing non-equiprobable and non-uniform (NENU)…
Visible light communications (VLC) are motivated by the radio-frequency (RF) spectrum crunch and fast-growing solid-state lighting technology. VLC relies on white light emitting diodes (LEDs) to provide communication and illumination…
Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…
Discrete Cosine Transform (DCT) can be used instead of conventional Discrete Fourier Transform (DFT) for the Orthogonal Frequency Division Multiplexing (OFDM) construction, which offers many advantages. In this paper, the…
Visible Light Communication (VLC) using light emitting diodes (LEDs) has been gaining increasing attention in recent years as it is appealing for a wide range of applications such as indoor positioning. Orthogonal frequency division…
Spectral efficiency is a key design issue for all wireless communication systems. Orthogonal frequency division multiplexing (OFDM) is a very well-known technique for efficient data transmission over many carriers overlapped in frequency.…