Related papers: Power-to-Frequency Conversion in Cryogenic Sapphir…
Microwave measurements have recently been successfully applied to measure ferroelectric materials on the nanoscale, including detection of polarization switching and ferroelectric domain walls. Here we discuss the question whether scanning…
Radio-frequency (RF) reflectometry is widely used for high-bandwidth readout of semiconductor quantum devices at cryogenic temperatures, but its application has mainly been limited to nanoscale structures with relatively small capacitances.…
The overall, loaded quality factor $Q_\mathrm{L}$ quantifies the loss of energy stored in a resonator. Here we discuss on general grounds how $Q_\mathrm{L}$ of a planar microwave resonator made of a conventional superconductor should depend…
In this paper we present details of the construction of a wideband, cryogenic receiver and its successful commissioning on the Arecibo 12m telescope. The cryogenic receiver works in the 2.5-14 GHz frequency range. The telescope is operated…
Here we analyse ways to achieve deep subthreshold parametric squeezing of fluctuations beyond the $-6$~dB limit of single degree-of-freedom parametric resonators. One way of accomplishing this is via a lock-in amplifier feedback loop.…
The wave property of phonons is employed to explore the thermal transport across a finite periodic array of nano-scatterers such as circular and triangular holes. As thermal phonons are generated in all directions, we study their…
We demonstrate the use of radio-frequency (rf) resonators to measure the capacitance of nano-scale semiconducting devices in field-effect transistor configurations. The rf resonator is attached to the gate or the lead of the device.…
We have measured the low frequency (1mHz<f<10Hz) resistance fluctuations in metallic nanowires (diameter 15nm to 200nm) in the temperature range 77K to 400K. The nanowires were grown electrochemically in polycarbonate membranes and the…
Modification of surface and volume of sapphire is shown to affect reflected and transmitted light at THz spectral range. Structural modifications were made using ultra-short 230 fs laser pulses at 1030 nm and 257.5 nm wavelengths forming…
Superconducting Quantum Interference Filters (SQIF) are promising devices for Radio- Frequency (RF) detection combining low noise, high sensitivity, large dynamic range and wide-band capabilities. Impressive progress have been made recently…
The paper describes a radio frequency (RF) spectrometer for 14N nuclear quadrupole resonance (NQR) spectroscopy that uses a detector coil cooled to 77 K to maximize measurement sensitivity. The design uses a minimally-intrusive network of…
We present a theoretical approach to study the effect of microwave radiation on the magnetoresistance of a one-dimensional superlattice. In our proposal the magnetoresistance of a unidirectional spatial periodic potential (superlattice), is…
Radio-frequency (RF) control is a key technique in cold atom experiments. We present a compact and efficient RF circuit based on a capacitive transformer network, where a low-frequency coil operating up to 30MHz serves as both an intrinsic…
We have developed a radio-frequency resonant spin rotator to reverse the neutron polarization in a 9.5 cm x 9.5 cm pulsed cold neutron beam with high efficiency over a broad cold neutron energy range. The effect of the spin reversal by the…
Here we present the design and implementation of a novel frequency synthesizer based on low phase noise digital dividers and a direct digital synthesizer. The synthesis produces two low noise accurate and tunable signals at 10 MHz and 100…
Transfer of amplitude and phase noise from a continuous wave optical pump to the repetition rate of a Kerr frequency comb is studied theoretically, with focus on generation of spectrally pure radio frequency (RF) signals via demodulation of…
The performance of superconducting resonators underpins a wide range of modern quantum technologies, yet their quality factor often deviates at low temperatures from standard Mattis-Bardeen predictions. This discrepancy is often attributed…
We studied the frequency and quality factor of mechanical plasmonic nanoresonators as a function of temperature, ranging from ambient to 4 K. Our investigation focused on individual gold nanorods and nanodisks of various sizes. We observed…
The microfluidic optomechanical resonator (uFOMR) based on a thin-walled glass capillary supports high Q-factor (>1000) mechanical modes in the presence of liquids. In this Letter, the sensitivity of the uFOMR to the surface change is…
Feedback-based control techniques are useful tools in precision measurements as they allow to actively shape the mechanical response of high quality factor oscillators used in force detection measurements. In this paper we implement a…