Related papers: Power-to-Frequency Conversion in Cryogenic Sapphir…
Optical measurements of a nanoscale silicon optomechanical crystal cavity with a mechanical resonance frequency of 3.6GHz are performed at sub-kelvin temperatures. We infer optical-absorption-induced heating and damping of the mechanical…
We demonstrate radio frequency (RF) readout of electrically detected magnetic resonance in phosphorus-doped silicon metal-oxide field-effecttransistors (MOSFETs), operated at liquid helium temperatures. For the first time, the Si:P…
We present the measurement of squeezed light generation using an engineered optomechanical system fabricated from a silicon microchip and composed of a micromechanical resonator coupled to a nanophotonic cavity. Laser light is used to…
Long-lived, high-frequency phonons are valuable for applications ranging from optomechanics to emerging quantum systems. For scientific as well as technological impact, we seek high-performance oscillators that offer a path towards…
We experimentally realize an incoherent microwave source driven by voltage-controlled quantum tunneling of electrons through nanoscale normal-metal--insulator--superconductor junctions coupled to a resonator. We observe the direct…
Nano- and micromechanical oscillators with high quality (Q) factors have gained much attention for their potential application as ultrasensitive detectors. In contrast to micro-fabricated devices, optically trapped nanoparticles in vacuum…
We report observations of the Schawlow-Townes noise limit in a cryogenic sapphire secondary frequency standard. The effect causes a fundamental limit to the frequency stability, and was measured through the novel excitation of a bimodal…
Optical frequency conversion has applications ranging from tunable light sources to telecommunications-band interfaces for quantum information science. Here, we demonstrate efficient, low-noise frequency conversion on a nanophotonic chip…
Ferrites are distinct material for electromagnetic applications due to its unique spin precession. In this paper, Casimir pressure effect by deploying magnetically tunable surface plasmon quanta in stratified structure of using ferrite and…
Nanomechanical resonators promise diverse applications ranging from mass spectrometry to quantum information processing, requiring long phonon lifetimes and frequency stability. Although two-level system (TLS) defects govern dissipation at…
We report on experimental demonstration of a new type of nanoelectromechanical resonators based on black phosphorus crystals. Facilitated by a highly efficient dry transfer technique, crystalline black phosphorus flakes are harnessed to…
Employing a broadband microwave reflection configuration, we have measured the complex surface impedance, $Z_S(\omega,T,H)$, of single crystal La$_{0.8}$Sr$_{0.2}$MnO$_3$, as a function of frequency (0.045-45 GHz), temperature (250-325 K),…
We measured the low frequency (10mHz < f < 10Hz) resistance fluctuations (Noise) in single crystalline ferromagnetic Ni nanowires (diameter ~35nm) in the temperature range 80K-300K. The noise spectral power shows 1/f dependence. The…
We report on fabrication of a microtoroid resonator of high-quality (high-Q) factor integrated with an on-chip microheater. Both the microresonator and microheater are fabricated using femtosecond laser three-dimensional (3D)…
We have employed a feedback cooling scheme, which combines high-frequency mixing with digital signal processing. The frequency and damping rate of a 2 MHz micromechanical resonator embedded in a dc SQUID are adjusted with the feedback, and…
Microring resonators are attractive for low-power frequency conversion via Bragg-scattering four-wave-mixing due to their comb-like resonance spectrum. However, conversion efficiency is limited to 50% due to the equal probability of up- and…
We present measurements of silicon nitride nonlinear microresonators and frequency comb generation at cryogenic temperatures as low as 7~K. The resulting two orders of magnitude reduction in the thermo-refractive coefficient relative to…
It is usual in helioseismology to remove unwanted instrumental low-frequency trends by applying high-pass filters to the time series. However, the choice of the filter is very important because it can keep the periodic signals throughout…
Frequency stability is key to performance of nanoresonators. This stability is thought to reach a limit with the resonator's ability to resolve thermally-induced vibrations. Although measurements and predictions of resonator stability…
We numerically and experimentally investigate the phononic loss for superconducting resonators fabricated on a piezoelectric substrate. With the help of finite element method simulations, we calculate the energy loss due to…