Related papers: Creep response of athermal amorphous solids under …
Yield stress fluids display complex dynamics, in particular when driven into the transient regime between the solid and the flowing state. Inspired by creep experiments on dense amorphous materials, we implement mesocale elasto-plastic…
We numerically investigate the athermal creep deformation of amorphous materials having a wide range of stability. The imposed shear stress serves as the control parameter, allowing us to examine the time-dependent transient response…
Creep is a time-dependent deformation of solids at relatively low stresses, leading to the breakdown with time. Here we propose a simple model for creep failure of disordered solids, in which temperature and stress are controllable. Despite…
Creep is a generic descriptor of slow motions -- in the context of materials, it describes quasi-static deformation of a solid when subjected to stresses below the global yield, at which all rigidity collapses and the material flows. Here,…
When submitted to a constant mechanical load, many amorphous solids display power law creep followed by fluidization. A fundamental understanding of these processes is still far from being achieved. Here, we characterize creep and…
We study theoretically the yielding of sheared amorphous materials as a function of increasing levels of initial sample annealing prior to shear, in three widely used constitutive models and three widely studied annealing protocols. In…
We extend our earlier shear-transformation-zone (STZ) theory of amorphous plasticity to include the effects of thermally assisted molecular rearrangements. This version of our theory is a substantial revision and generalization of…
We study the creep behavior of a disordered brittle material (concrete) under successive loading steps, using acoustic emission and ultrasonic sensing to track internal damage. The primary creep rate is observed to follow a (Omori-type)…
The stress-induced yielding scenario of colloidal gels is investigated under rough boundary conditions by means of rheometry coupled to local velocity measurements. Under an applied shear stress, the fluidization of gels made of attractive…
Widespread processes in nature and technology are governed by the dynamical transition whereby a material in an initially solid-like state then yields plastically. Major unresolved questions concern whether any material will yield smoothly…
Sloped terrains tend to creep downward over time, even when their slope is below the nominal angle of repose. This behavior can result from periodic variations in environmental conditions, such as daily or seasonal fluctuations in…
We study the internal dynamical processes taking place in a granular packing below yield stress. At all packing fractions and down to vanishingly low applied shear, a logarithmic creep is evidenced. The experiments are analyzed under the…
The creep behavior of an amorphous poly(etherimide) (PEI) polymer is investigated in the vicinity of its glass transition in a weakly non linear regime where the acceleration of the creep response is driven by local configurational…
Granular packings display a wealth of mechanical features which are of widespread significance. One of these features is creep: the slow deformation under applied stress. Creep is common for many other amorphous materials such as many…
Stressed under a constant load, materials creep with a final acceleration of deformation and for any given applied stress and material, the creep failure time can strongly vary. We investigate creep on sheets of paper and confront the…
The creep behavior of an amorphous poly(etherimide) (PEI) polymer is investigated in the vicinity of its glass transition in a weakly non linear regime where the acceleration of the creep response is driven by local configurational…
Amorphous solids increase their stress as a function of an applied strain until a mechanical yield point whereupon the stress cannot increase anymore, afterwards exhibiting a steady state with a constant mean stress. In stress controlled…
Creep failure of hierarchical materials is investigated by simulation of beam network models. Such models are idealizations of hierarchical fibrous materials where bundles of load-carrying fibers are held together by multi-level…
We develop an elasto-plastic description for the transient dynamics prior to steady flow of athermally yielding materials. Our mean-field model not only reproduces the experimentally observed non-linear time dependence of the shear-rate…
We study computationally the creep and yielding of athermal gels and fibre network materials under a constant imposed shear stress, within a minimal model of interconnected filaments with central forces in $d=2$ spatial dimensions. Each…