Related papers: Joint On-Manifold Gravity and Accelerometer Intrin…
Inertial measurement units (IMUs), which provide high-frequency linear acceleration and angular velocity measurements, serve as fundamental sensing modalities in robotic systems. Recent advances in deep neural networks have led to…
Recently, multi-node inertial measurement unit (IMU)-based odometry for legged robots has gained attention due to its cost-effectiveness, power efficiency, and high accuracy. However, the spatial and temporal misalignment between foot-end…
Nowadays, more and more sensors are equipped on robots to increase robustness and autonomous ability. We have seen various sensor suites equipped on different platforms, such as stereo cameras on ground vehicles, a monocular camera with an…
In recent years, Onboard Self Localization (OSL) methods based on cameras or Lidar have achieved many significant progresses. However, some issues such as estimation drift and feature-dependence still remain inherent limitations. On the…
We present an efficient multi-sensor odometry system for mobile platforms that jointly optimizes visual, lidar, and inertial information within a single integrated factor graph. This runs in real-time at full framerate using fixed lag…
In this paper, we present INertial Lidar Localisation Autocalibration And MApping (IN2LAAMA): an offline probabilistic framework for localisation, mapping, and extrinsic calibration based on a 3D-lidar and a 6-DoF-IMU. Most of today's…
This paper presents a novel online capable method for simultaneous estimation of human motion in terms of segment orientations and positions along with sensor-to-segment calibration parameters from inertial sensors attached to the body. In…
Inertial Odometry (IO) has gained attention in quadrotor applications due to its sole reliance on inertial measurement units (IMUs), attributed to its lightweight design, low cost, and robust performance across diverse environments.…
A simple approach to gyro and accelerometer bias estimation is proposed. It does not involve Kalman filtering or similar formal techniques. Instead, it is based on physical intuition and exploits a duality between gimbaled and strapdown…
Legged robots carry an IMU, but the inertial solution drifts because consumer-grade IMUs are noisy. However, the feet create intermittent contacts with the environment that can be used to mitigate that drift. This report develops a sequence…
The design of a globally convergent position observer for feature points from visual information is a challenging problem, especially for the case with only inertial measurements and without assumptions of uniform observability, which…
To address the weak observability of monocular visual-inertial odometers on ground-based mobile robots, this paper proposes a monocular inertial SLAM algorithm combined with wheel speed anomaly detection. The algorithm uses a wheel speed…
This paper presents a visual-inertial odometry-enhanced geometrically stable Iterative Closest Point (ICP) algorithm for accurate mapping using aerial robots. The proposed method employs a visual-inertial odometry framework in order to…
Modern autonomous vehicles and robots utilize versatile sensors for localization and mapping. The fidelity of these maps is paramount, as an accurate environmental representation is a prerequisite for stable and precise localization. Factor…
In recent years there have been excellent results in Visual-Inertial Odometry techniques, which aim to compute the incremental motion of the sensor with high accuracy and robustness. However these approaches lack the capability to close…
Radar ensures robust sensing capabilities in adverse weather conditions, yet challenges remain due to its high inherent noise level. Existing radar odometry has overcome these challenges with strategies such as filtering spurious points,…
Inertial navigation systems for pedestrians are infrastructure-less and can achieve sub-meter accuracy in the short/medium period. However, when low-cost inertial measurement units (IMU) are employed for their implementation, they suffer…
Multiple rigidly attached Inertial Measurement Unit (IMU) sensors provide a richer flow of data compared to a single IMU. State-of-the-art methods follow a probabilistic model of IMU measurements based on the random nature of errors…
Visual-Inertial Odometry (VIO) is the problem of estimating a robot's trajectory by combining information from an inertial measurement unit (IMU) and a camera, and is of great interest to the robotics community. This paper develops a novel…
Involuntary motion during weight-bearing cone-beam computed tomography (CT) scans of the knee causes artifacts in the reconstructed volumes making them unusable for clinical diagnosis. Currently, image-based or marker-based methods are…