Related papers: Lattice All-Pass Filter based Precoder Adaptation …
This paper proposes an adaptive multi-mode transmission strategy to improve the spectral efficiency achieved in the multiple-input multiple-output (MIMO) broadcast channel with delayed and quantized channel state information. The adaptive…
As radio-frequency (RF) antenna, component and processing capabilities increase, the ability to perform multiple RF system functions from a common aperture is being realized. Conducting both radar and communications from the same system is…
The design of precoding plays a crucial role in achieving a high downlink sum-rate in multiuser multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems. In this correspondence, we propose a deep…
The optimal diversity-multiplexing-delay tradeoff for the multi-input multi-output (MIMO) automatic repeat request (ARQ) channel can be achieved using incremental redundancy lattice space-time codes coupled with a list decoder for joint…
In-band full-duplex transmission allows a relay station to theoretically double its spectral efficiency by simultaneously receiving and transmitting in the same frequency band, when compared to the traditional half-duplex or out-of-band…
This paper investigates the design of precoders for single-user multiple-input multiple-output (MIMO) channels, and in particular for finite-alphabet signals. Based on an asymptotic expression for the mutual information of channels…
Conventional hybrid analog-digital architectures for millimeter-wave massive multiple-input multiple-output (MIMO) systems suffer from poor scalability and high implementational costs. The former is caused by the high power loss in the…
Diversity order is an important measure for the performance of communication systems over MIMO fading channels. In this paper, we prove that in MIMO multiple access systems (or MIMO point-to-point systems with V-BLAST transmission),…
We consider the problem of degradation in performance of multi-carrier multi-user massive MIMO systems when channel induced Doppler spread is high. Recently, Orthogonal Time Frequency Space (OTFS) modulation has been shown to be robust to…
The Future wireless communication systems face the challenging task of simultaneously providing high quality of service (QoS) and broadband data transmission, while also minimizing power consumption, latency, and system complexity. Although…
Waveform evaluation for sixth generation (6G) networks has largely relied on sparse and quasi-stationary channel models that enabled mathematical tractability, diversity gains, and Doppler robustness. However, such models obscure the…
The space limitation and the channel acquisition prevent Massive MIMO from being easily deployed in a practical setup. Motivated by current deployments of LTE-Advanced, the use of multi-polarized antennas can be an efficient solution to…
We investigate quantization and feedback of channel state information in a multiuser (MU) multiple input multiple output (MIMO) system. Each user may receive multiple data streams. Our design minimizes the sum mean squared error (SMSE)…
In communications theory, the capacity of multiple input multiple output-orthogonal frequency division multiplexing (MIMO-OFDM) systems is fundamentally determined by wireless channels, which exhibit both diversity and correlation in…
In this paper, we propose a cross subcarrier precoder design (CSPD) for massive multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems. The aim is to maximize the weighted sum-rate (WSR) performance…
The orthogonal frequency division multiplexing is a very efficient modulation technique that can achieve very high throughput by transmitting many carriers simultaneously and it is spectrally efficient because of the proximity of the…
Motivated by MIMO broad-band fading channel model, in this section a comparative study is presented regarding various uncoded adaptive and non-adaptive MIMO detection algorithms with respect to BER/PER performance, and hardware complexity.…
Configuring hybrid precoders and combiners is a major challenge to deploy practical mmWave communication systems. Prior work addresses the problem of designing hybrid precoders and combiner, yet focusing on finding solutions under a total…
Millimeter-wave (mmWave) networks have the potential to support high throughput and low-latency requirements of 5G-and-beyond communication standards. But transmissions in this band are highly vulnerable to attenuation and blockages from…
Wireless Power Transfer (WPT) is expected to be a technology reshaping the landscape of low-power applications such as the Internet of Things, Radio Frequency identification (RFID) networks, etc. Although there has been some progress…