Related papers: Lattice All-Pass Filter based Precoder Adaptation …
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…
Precoding for multiple-input, multiple-output (MIMO) antenna systems is considered with perfect channel knowledge available at both the transmitter and the receiver. For 2 transmit antennas and QAM constellations, an approximately optimal…
This paper investigates the design of distributed precoding for multi-satellite massive MIMO transmissions. We first conduct a detailed analysis of the transceiver model, in which delay and Doppler precompensation is introduced to ensure…
Due to its attractive properties, generalized frequency division multiplexing (GFDM) is recently being discussed as a candidate waveform for the fifth generation of wireless communication systems (5G). GFDM is introduced as a generalized…
The focus of this paper is on spatial precoding in correlated multi-antenna channels, where the number of independent data-streams is adapted to trade-off the data-rate with the transmitter complexity. Towards the goal of a low-complexity…
The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…
Massive MIMO is a promising technology in future wireless communication networks. However, it raises a lot of implementation challenges, for example, the huge pilot symbols and feedback overhead, requirement of real-time global CSI, large…
A major source of difficulty when operating with large arrays at mmWave frequencies is to estimate the wideband channel, since the use of hybrid architectures acts as a compression stage for the received signal. Moreover, the channel has to…
As the number of antennas in frequency-division duplex (FDD) multiple-input multiple-output (MIMO) systems increases, acquiring channel state information (CSI) becomes increasingly challenging due to limited spectral resources and feedback…
Recent information theoretic results suggest that precoding on the multi-user downlink MIMO channel with delayed channel state information at the transmitter (CSIT) could lead to data rates much beyond the ones obtained without any CSIT,…
Future wireless communication systems are demanding a more flexible physical layer. GFDM is a block filtered multicarrier modulation scheme proposed to add multiple degrees of freedom and cover other waveforms in a single framework. In this…
This paper introduces a practical precoding method for the downlink of Filter Bank Multicarrier-based (FBMC-based) massive multiple-input multiple-output (MIMO) systems. The proposed method comprises a two-stage precoder, consisting of a…
The expected operating scenarios of 5G pose a great challenge to orthogonal frequency division multiplexing (OFDM) which has poor out of band (OoB) spectral properties, stringent synchronization requirements, and large symbol duration.…
Millimeter wave (mmWave) communications have been considered as a key technology for next generation cellular systems and Wi-Fi networks because of its advances in providing orders-of-magnitude wider bandwidth than current wireless…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Next generation wireless communications rely on multiple input multiple output (MIMO) techniques to achieve high data rates. Feedback of channel information can be used in MIMO precoding to fully activate the strongest channel modes and…
Fifth generation (5G) wireless systems are expected to combine emerging transmission technologies, such as large-scale multiple-input multiple-output (MIMO) and non-orthogonal multi-carrier waveforms, to improve the spectral efficiency and…
Future wireless communication systems must simultaneously address multiple challenges to ensure accurate data detection, deliver high Quality of Service (QoS), adding enable a high data transmission with low system design. Additionally,…
This paper addresses the joint transceiver design, including pilot transmission, channel feature extraction and feedback, as well as precoding, for low-overhead downlink massive multiple-input multiple-output (MIMO) communication in…