Related papers: CMS Tracker Alignment: Legacy results from LHC Run…
The physics goals the Belle II experiment require an exceptionally good alignment of all the components of the Belle II tracker. The Belle II tracker is composed of the DEPFET based pixel silicon detector, four layers of double sided…
A track finding algorithm has been developed for reconstruction of e+e- pairs. It combines the information of the electromagnetic calorimeter with the information provided by the Tracker. Results on reconstruction efficiency of converted…
Conformance checking deals with collating modeled process behavior with observed process behavior recorded in event data. Alignments are a state-of-the-art technique to detect, localize, and quantify deviations in process executions, i.e.,…
The software alignment of planar tracking detectors using samples of charged particle trajectories may lead to global detector distortions that affect vertex and momentum resolution. We present an alignment procedure that constrains such…
Two fast trigger algorithms based on 3 innermost hits in the CMS Inner Tracker are presented. One of the algorithms will be applied at LHC low luminosity to select B decay channels. Performance of the algorithm is demonstrated for the decay…
Radiation damage significantly impacts the performance of silicon tracking detectors in Large Hadron Collider (LHC) experiments such as ATLAS and CMS, with signal reduction being the most critical effect; adjusting sensor bias voltage and…
The CMS inner pixel detector system is planned to be replaced during the first phase of the LHC luminosity upgrade. The plans foresee an ultra low mass system with four barrel layers and three disks on either end. With the expected increase…
The 2009 run provided the first proton-proton collisions from the Large Hadron Collider (LHC) at center of mass energies of 900 GeV and 2.36 TeV. The Compact Muon Solenoid (CMS) experiment has recorded a large sample of minimum bias events…
During the High Luminosity programme of the LHC collider (called HL-LHC), planned to start in 2030, the instantaneous luminosity will be increased from \num{\sim 2e34}~\si{cm^{-2}s^{-1}} to an unprecedented figure of about \num{\sim…
Charged-particle reconstruction is a fundamental part of the event reconstruction in modern multi-purpose high-energy physics detectors. This paper describes the algorithms used to reconstruct charged particles and primary vertices with the…
Reconstructing the trajectories of charged particles from the collection of hits they leave in the detectors of collider experiments like those at the Large Hadron Collider (LHC) is a challenging combinatorics problem and computationally…
Radiation damage significantly impacts the performance of silicon tracking detectors in Large Hadron Collider (LHC) experiments such as ATLAS and CMS, with signal reduction being the most critical effect. Adjusting sensor bias voltage and…
During the scheduled high luminosity upgrade of LHC, the world's largest particle physics accelerator at CERN, the position sensitive silicon detectors installed in the vertex and tracking part of the CMS experiment will face more intense…
We report on preliminary design studies of a pixel detector for CMS at the Super-LHC. The goal of these studies was to investigate the possibility of designing an inner tracker pixel detector whose data could be used for selecting events at…
In LHC Run 3, ALICE will increase the data taking rate significantly to continuous readout of 50 kHz minimum bias Pb-Pb collisions. The reconstruction strategy of the online offline computing upgrade foresees a first synchronous online…
The CMS Electromagnetic Calorimeter (ECAL) is a high resolution crystal calorimeter operating at the CERN LHC. It is responsible for the identification and precise reconstruction of electrons and photons in CMS, which were crucial in the…
The determination of charged particle trajectories (tracking) in collisions at the CERN Large Hadron Collider (LHC) is one of the most important aspects for event reconstruction at hadron colliders. This is especially true in the high…
In March 2007 the assembly of the Silicon Strip Tracker was completed at the Tracker Integration Facility at CERN. Nearly 15% of the detector was instrumented using cables, fiber optics, power supplies, and electronics intended for the…
In preparation for HL-LHC operation a number of new detector systems are being constructed with timing precision on physics objects of <50 picoseconds. These time stamps will reduce the level of pileup induced backgrounds in this LHC phase…
Microelectromechanical systems (MEMS) that require contact of moving parts to implement complex functions exhibit limits to their performance and reliability. Here, we advance our particle tracking method to measure MEMS motion in operando…