Related papers: Introduction to Non-Invasive Current Estimation (N…
We propose a new method to measure the system noise temperature, $T_{\rm sys}$, using a 2-bit analog-to-digital converter (ADC). The statistics of the digitized signal in a four-level quantization brings us information about the bias…
This paper presents the effectiveness of convolutional neural network (CNN) to classify power quality problems. These problems arise mainly due to increase in use of non-linear loads, operation of devices like adjustable speed drives and…
Many real-life signals, such as gravitational wave measurements, biomedical signals, or geophysical data, are strongly non-stationary but can be decomposed into mono-component signals that contain only one active frequency over time. This…
We investigate the effects of charged-current (CC) nonstandard neutrino interactions (NSIs) at the source and at the detector in the simulated data for the planned Deep Underground Neutrino Experiment (DUNE), while neglecting the…
Variational quantum algorithms are promising for near-term quantum computing, but are severely limited by hardware noise and the substantial circuit overhead required for error mitigation methods such as Zero-Noise Extrapolation (ZNE). We…
In full-duplex systems, oscillator phase noise (PN) problem is considered the bottleneck challenge that may face the self-interference cancellation (SIC) stage especially when orthogonal frequency division multiplexing (OFDM) transmission…
Continuous-time random disturbances (also called stochastic excitations) due to increasing renewable generation have an increasing impact on power system dynamics; However, except from the Monte Carlo simulation, most existing methods for…
The increasing adoption of measurement units in electrical power distribution grids has enabled the deployment of data-driven and measurement-based control schemes. Such schemes rely on measurement-based estimated models, where the models…
Probabilistic power flow (PPF) analysis is critical to power system operation and planning. PPF aims at obtaining probabilistic descriptions of the state of the system with stochastic power injections (e.g., renewable power generation and…
Conventional electrical fault models, which rely on static thresholds and instantaneous trip mechanisms, fail to capture the time-evolving dynamics of real faults, creating vulnerabilities in modern power systems. This paper introduces a…
We consider the problem of designing a data-driven nonlinear state estimation (DANSE) method that uses (noisy) nonlinear measurements of a process whose underlying state transition model (STM) is unknown. Such a process is referred to as a…
A fast-reading current integrator is developed for high time-resolution and low-noise ion beam diagnostics under both continuous-wave and pulsed operating conditions. The system combines a low-leakage transimpedance front-end with a hybrid…
With the rapid development of science and technology, the problem of energy load monitoring and decomposition of electrical equipment has been receiving widespread attention from academia and industry. For the purpose of improving the…
Event detection is the first step in event-based non-intrusive load monitoring (NILM) and it can provide useful transient information to identify appliances. However, existing event detection methods with fixed parameters may fail in case…
Accurate and quick identification of high-impedance faults is critical for the reliable operation of distribution systems. Unlike other faults in power grids, HIFs are very difficult to detect by conventional overcurrent relays due to the…
Uninterruptible power supply is the main motive of power utility companies that motivate them for identifying and locating the different types of faults as quickly as possible to protect the power system prevent complete power black outs…
This paper presents a method for developing single and multi-port frequency dependent network equivalent (FDNE) based on a passivity enforced online recursive least squares identification algorithm, which identifies the input admittance…
Large scale circuit simulation, such as power delivery network analysis, has become increasingly challenge in the VLSI design verification flow. Power delivery network can be simulated by both SPICE-type circuit-based model and…
In the recent years, there has been an increasing academic and industrial interest for analyzing the electrical consumption of commercial buildings. Whilst having similarities with the Non Intrusive Load Monitoring (NILM) tasks for…
The increasing integration of intermittent renewable generation, especially at the distribution level,necessitates advanced planning and optimisation methodologies contingent on the knowledge of thegrid, specifically the admittance matrix…