Related papers: Two-Phase Flow Simulations of Surface Waves in Win…
The study presents wall-modeled large-eddy simulations (LES) characterizing the flow features of a neutral atmospheric boundary layer over two urban-like roughness geometries: an array of three-dimensional square prisms and the…
An existing phase-field model of two immiscible fluids with a single soluble surfactant present is discussed in detail. We analyze the well-posedness of the model and provide strong evidence that it is mathematically ill-posed for a large…
The flow of a two--layer stratified fluid over an abrupt topographic obstacle, simulating relevant situations in oceanographic problems, is investigated numerically and experimentally in a simplified two--dimensional situation. Experimental…
Knowledge of turbulent flows over non-flat surfaces is of major practical interest in diverse applications. Significant work continues to be reported in the roughness regime at high Reynolds numbers where the cumulative effect of surface…
A two-phase model and its application to wavefields numerical simulation are discussed in the context of modeling of compressible fluid flows in elastic porous media. The derivation of the model is based on a theory of thermodynamically…
Direct Numerical Simulations are used to solve turbulent flow and heat transfer over a variety of rough walls in a channel. The wall geometries are exactly resolved in the simulations. The aim is to understand the effect of roughness…
In multiphase flow phenomena, bubbles and droplets are advected, deformed, break up into smaller ones, and coalesce with each other. A primary challenge of classical computational fluid dynamics (CFD) methods for such flows is to…
Turbulent signals are known to exhibit burst-like activities, which affect the turbulence statistics at both large and small scales of the flow. In our study, we pursue this problem from the perspective of an event-based framework, where…
Two different cartesian-grid methods are used to simulate the flow around the DDG 5415. The first technique uses a "coupled level-set and volume-of-fluid" (CLS) technique to model the free-surface interface. The no-flux boundary condition…
Fan-array wind generators (FAWGs) provide controlled turbulent inflow conditions that cannot be reproduced in conventional wind tunnels. Despite their increasing use in experimental studies, numerical modeling of FAWG-generated flows…
The accurate prediction of aerothermal surface loading is of paramount importance for the design of high speed flight vehicles. In this work, we consider the numerical solution of hypersonic flow over a double-finned geometry,…
Wind-wave interactions impose wind forcing on wave surface and wave effects on turbulent wind structures, which essentially influences the wind-wave loading on structures. Existing research treats the wind and wave loading separately and…
Airflow simulation results depend on a good prediction of near wall turbulence. In this paper a comparative study between different near wall treatments is presented. It is applied to two test cases: (1) the first concerns the fully…
One of the prevailing challenges in Computational Fluid Dynamics is accurate simulation of two-phase flows involving heat and mass transfer across the fluid interface. This is currently an active field of research, which is to some extend…
Based on the two-phase macroscopic governing equations in the phase field model, the governing equations and analytical solutions for the steady-state layered Poiseuille flows in the diffuse interface (DI) model are derived and analyzed.…
The simulation of turbulent flow requires many degrees of freedom to resolve all the relevant times and length scales. However, due to the dissipative nature of the Navier-Stokes equations, the long-term dynamics are expected to lie on a…
Pore-resolved direct numerical simulations of turbulent open channel flow are performed comparing the structure and dynamics of turbulence over impermeable rough and smooth walls to a porous sediment bed at permeability Reynolds number…
In this paper, wall-modeled large-eddy simulation (WMLES) is carried out with Ffowcs-Williams and Hawkings (FW-H) acoustic analogy to investigate the turbulent flow and hydrodynamic noise of an axisymmetric body of revolution. We first…
We present a framework for Large Eddy Simulations (LES) with Immersed Boundaries (IBs) to simulate high Reynolds number flows over complex walls. In this approach, which we call Immersed Boundary-Modeled LES (IBMLES), we volume-filter the…
Compressible interfacial multiphase flows (CIMF) are essential to different applications, such as liquid fuel injection in supersonic propulsion systems. Since high-level details in CIMF are often difficult to measure in experiments,…