Related papers: Saving Energy in Turbulent Flows with Unsteady Pum…
We show that the energy required by a turbulent flow to displace a given amount of fluid through a straight duct in a given time interval can be reduced by modulating in time the pumping power. The control strategy is hybrid: it is passive,…
In most settings, from international pipelines to home water supplies, the drag caused by turbulence raises pumping costs many times higher than if the flow were laminar. Drag reduction has therefore long been an aim of high priority. In…
Turbulence accounts for most of the energy losses associated with the pumping of fluids in pipes. Pulsatile drivings can reduce the drag and energy consumption required to supply a desired mass flux, when compared to steady driving.…
Injection of dilute polymer in a turbulent flow suppresses frictional drag. This challenging and technologically important problem remains primarily unresolved due to the complex nature of the flow. An important factor in the drag reduction…
In this review, we describe turbulent drag reduction in a variety of flows using a universal framework of energy flux. In a turbulent flow with dilute polymers and magnetic field, the kinetic energy injected at large scales cascades to the…
A turbulent pipe flow experiment was conducted where the surface of the pipe was oscillated azimuthally over a wide range of frequencies, amplitudes and Reynolds number. The drag was reduced by as much as 30\%. Past work has suggested that…
Steady forcing at the wall of a channel flow is studied via DNS to assess its ability of yielding reductions of turbulent friction drag. The wall forcing consists of a stationary distribution of spanwise velocity that alternates in the…
Energy dynamics calculations in a 3D fluid simulation of drift wave turbulence in the linear Large Plasma Device (LAPD) [W. Gekelman et al., Rev. Sci. Inst. 62, 2875 (1991)] illuminate processes that drive and dissipate the turbulence.…
We address the phenomenon of drag reduction by dilute polymeric additive to turbulent flows, using Direct Numerical Simulations (DNS) of the FENE-P model of viscoelastic flows. It had been amply demonstrated that these model equations…
This paper describes a robust linear time-invariant output-feedback control strategy to reduce turbulent fluctuations, and therefore skin-friction drag, in wall-bounded turbulent fluid flows, that nonetheless gives performance guarantees in…
Flow control with the goal of reducing the skin friction drag on the fluid-solid interface is an active fundamental research area, motivated by its potential for significant energy savings and reduced emissions in the transport sector.…
The frictional forces of a viscous liquid flow are a major energy loss issue and severely limit microfluidics practical use. Reducing this drag by more than a few tens of percent remain illusive. Here, we show how cylindrical…
A small amount of polymer additives can cause substantial reduction in the energy dissipation and friction loss of turbulent flow. The problem of polymer-induced drag reduction has attracted continuous attention over the seven decades since…
This paper addresses the integral energy fluxes in natural and controlled turbulent channel flows, where active skin-friction drag reduction techniques allow a more efficient use of the available power. We study whether the increased…
After decades of experimental, theoretical, and numerical research in fluid dynamics, many aspects of turbulence remain poorly understood. The main reason for this is often attributed to the multiscale nature of turbulent flows, which poses…
Flow instability and turbulent transition can be well explained using a new proposed theory--Energy gradient theory [1]. In this theory, the stability of a flow depends on the relative magnitude of energy gradient in streamwise direction…
We experimentally assess the capabilities of an active, open-loop technique for drag reduction in turbulent wall flows recently introduced by Quadrio et al. [J. Fluid Mech., v.627, 161, (2009)]. The technique consists in generating…
We derive a limit on energy savings in controlled channel flow. For flow in a channel driven by pressure, shear, or any combination of the two, and controlled via wall transpiration or spanwise wall motion, the uncontrolled laminar state…
Fluid dynamics in intrinsically curved geometries is encountered in many physical systems in nature, ranging from microscopic bio-membranes all the way up to general relativity at cosmological scales. Despite the diversity of applications,…
In technical applications, more than 90\% of the energy required to pump the fluids through pipes is dissipated by turbulence near the wall. In this respect, streamwise traveling waves of wall blowing and suction have been used to…